The power connectors used by both 5.25-inch and 3.5-inch floppy drives are 4-pin connectors. The larger connector--used by 5.25-inch drives--is called a Molex or peripheral cable. This type of cable is also used by IDE/ATA hard drives and optical drives. The smaller 4-pin cable used by 3.5-inch floppy drives is generally called a floppy power cable.
After you mechanically install it into the slot of the computer, you have a wire that connects to the mother board(I believe).
Power Rangers Turbo - 1997 A Drive to Win 1-14 was released on: USA: 19 May 1997
that is the drive assembly which the power provided by the rotation of the crankshaft and through the engine drive belt causes the rotaion of the alternator which produces the electrical power to the auto and battery charging system
( # 41 ) - 20 amp mini fuse - cigar lighter , diagnostic connector power according to the owners manual
It's a Pontiac Fire Bird.
4-Pin Berg connector
Mini Connector
berg
your power supply has a small plug attach to it with several larger ones that go to your cdrom and hard drive it will fit in to the back of your floppy
A "Berg" connector.
The drive appears to be a bad one. Why do you need a floppy disc drive anyways?
a cable from the power supply to the Berg power connector on the FDD a cable from the 20-pin ATX power connector socket on the motherboard to the Berg power connector on the FDD
There are two cables that connect to the floppy drive in a desktop computer.There is a four pin power cableThere is a ribbon cable that has a part twisted end (the twisted end connects to the floppy drive).
not sure what it is called by name but it is a 4 pin plug most of the time.
It varies. There's no universally adopted external floppy disk drive standard, so it depends on the type of drive and/or computer you have. Modern (2008) external floppy drives commonly use USB (Universal Serial Bus). This isn't really a "floppy drive connector"; it's just an ordinary USB connector. The drive unit itself contains the electronics to make the floppy drive work with USB computers. The original IBM-PC line (circa 1981) included an external floppy drive option, which used a 37-pin D-shell sub-miniature connector. These weren't all that common to begin with, and are extremely rare these days. The early Macintosh computers (circa 1984) included an external floppy drive port, which used a 19-pin D-shell sub-miniature connector. SCSI floppy disk drives exist, but were always fairly rare. Some manufacturers introduced external floppy drives with manufacturers-specific (non-standard) connectors. Generally, you had to use the manufacturer's expansion card and floppy drive together. Some manufacturer external floppy connectors were mechanically compatible with the 25-pin D-shell sub-miniature parallel port connector. This allowed the same computer port to be used for either printer or floppy. However, parallel and floppy are not electrically compatible, so only a computer specifically designed for this would work. Dell used it in some of their laptops (Latitude C series, for example).
A Berg connector is used for providing power to floppy drives and sometimes other peripherals.
Connecting a floppy Drive in a Desktop ComputerYou should connect the 4-Pin 12 Volt non-molex Connector from the power supply to the power input of the Floppy Disk Drive, also the IDE ribbon cable from the FDD output on the Main-board to the FDD input on the Floppy Disk Drive, with the pink stripe on the outside of the FDD Input & Output sockets, it is important to make sure you are grounded to the case whilst doing this with the PC Power Cord plugged in but switched off