well i had the same problem on my 1997 Jeep country and the problem was that there is a fuse in the fuse box under you hood that should be labled IOD and that is the fuse that controls all the controls on your dash..i replaced that one in my jeep and everything worked just fine..if not that then somthing electrical prolly
Bad sending unit in tank.
The cluster is another name for the gauge assembly.
fuel gauge not working and power windows and radio.2004 mercury mountaineer.
You have a ground from the oil sender unit to the gauge. This is how you check a gauge. ground out the wire at the sender and it pegs out the gauge.
It is probably a bad speed sensor. The speed sensor is located on the transmission and sends a signal to the speedometer. It acts like a speedometer cable only sending electronic pulses instead of turning like a cable does.
The gauge has failed.
speedo has a wire from behind and it snaps loose sometimes. disassemble the dash and reattach it
93 tranny is electronic if your speedo isn't working it won't shift into 3 or OD. Your speed sensor is more than likely the problem.
The odometer unit has failed and will need replaced.
If the temperature gauge is not working, one thing it could be besides the gauge itself is a blown fuse. Another possibility is a loose or broken wire on the gauge.Ê
Bad sending unit in tank.
Pull the speedo and gauge package out of dash. Unhook wiring. Remove speedo cable from speedometer. Pull speedo cable out of housing, lube it lightly and re-insert. Hook everything back up and re-install gauges. Pull the speedo and gauge package out of dash. Unhook wiring. Remove speedo cable from speedometer. Pull speedo cable out of housing, lube it lightly and re-insert. Hook everything back up and re-install gauges. Pull the speedo and gauge package out of dash. Unhook wiring. Remove speedo cable from speedometer. Pull speedo cable out of housing, lube it lightly and re-insert. Hook everything back up and re-install gauges. Remove gauge package. Remove wires and speedo cable housing. Pull speedo cable out, lightly lube with grease and re-insert. Hook everything back up and re-install gauge packege.
the fuel gauge is incorporated inside the speedo meter in the super bug.
Possibilities... I'd be looking for a wiring fault or a fault in the CECU or mismatched programming between the CECU and the instrument cluster node.
Sounds like the speedo cable may have snapped www.mr2-ben.co.uk Toyota mr2 mk2 New & Used parts
A 1990 Jeep Cherokee malfunctioning fuel gauge can be caused by a broken ground wire. The gauge will not function if the fuel float in the fuel tank is broken.
my gas gauge is not working what could be the problem