answersLogoWhite

0

Usually, the line feeding the recepticle has a collar that simply slips back away from the recepticle (You may have to push the line forward and then pull back on the collar.) Then it should release.

User Avatar

Wiki User

17y ago

What else can I help you with?

Continue Learning about Music & Radio

Where is the fuel rail schrader valve on a 1997 pathfinder?

The 1997 Nissan Pathfinder does not have a schrader valve. If you want to test the fuel pressure system (fuel pump, lines, pressure regulator) you have to insert a 'T' in the fuel line under the hood and connect a fuel pressure gauge to the 'T'.


How do you remove fuel tank from a 31 chris craft scorpion?

To remove the fuel tank from a 31 Chris Craft Scorpion, first ensure the boat is safely secured and the fuel system is depressurized. Disconnect the fuel lines and electrical connections from the tank. Then, remove any screws or fasteners securing the tank in place, and carefully lift it out of its compartment. It's advisable to have a second person assist with this process to ensure safe handling and prevent damage.


On your 1988 Toyota Camry you cleaned the fuel tank and lines and replaced the fuel pump The car will start and run for 5 minutes and then shutdown like it is fuel starved what am you missing?

change your fule pump relay and this should solve your problem


How do I replace the fuel filter on 1998 Jeep Grand Cherokee?

You don't - according to the service manual. If you must it is located INSIDE the fuel tank as part of the fuel pump assembly. The fuel tank must be drained and removed to complete the procedure.


How to start Mg midget that has not been started in 4 years?

Drain the fuel tank and all fuel lines. Install fresh gasoline. Change the oil and filter. Replace the battery and spark plugs. Use starter fluid to get it going.

Related Questions

Location of fuel filter 07 Chevy colbalt?

if you look from the rear of the vehicle on the underneath, the fuel filter is on the passenger side above the rear beam. It has 3 fule lines that connect into it and requires a quick disconnect tool to remove the fuel lines.


How do you disconnect Ford fuel lines?

Go to your local auto parts house and buy the special tool for ford quick discaonnect fuel lines.


Do you need a special tool to remove the fuel lines on 2004 suzuki aerio?

Yes, to remove the fuel lines on a 2004 Suzuki Aerio, you typically need a special fuel line disconnect tool. This tool helps release the quick-connect fittings without damaging the lines. Additionally, it's important to relieve the fuel system pressure before attempting to disconnect the lines to ensure safety. Always refer to the vehicle's service manual for specific instructions and precautions.


How do you replace the fuel filter located on a 2002 Ford F-150 5.4L?

Use a fuel/AC quick disconnect tool to remove fuel lines from filter. Plug fuel lines as they removed to reduce amount of fuel spilt. Remove 1/2" nut, located on outside of frame, that holds filter retaining clip inplace. Exchange filters and reattach retaining clip. Use quick disconnect tool to reattach fuel lines.


How do you remove the v6 ford ranger fuel-line locks?

You need to get a quick disconnect tool from any parts house to remove the fuel lines.


How do you replace the Rubber Fuel line hose on a 1993 Buick Regal Gran Sport?

You have to drop fuel tank and use quick disconnect tool to change lines


What is the name of the tool needed to remove fuel lines from the fuel tank on a 1994 ford bronco?

Its called a Quick-disconnect tool its like 10-15$ at a parts store


How do you disconnect the quick disconnect fuel line on a 1998 grand voyager?

buy a fuel Quick disconnect tool. They make cheap plastic ones, and slightly more expensive metal ones


How do you remove fuel tank 93 Thunderbird?

First remove gas cap, then disconnect exhaust from flange by fuel tank. Disconnect fuel pump electrical connection, disconnect fuel filler hose and evap line from top of tank. Disconnect quick connect fittings on top of tank. Lower tank. This procedure should be done with the tank less then 1/4 full.


Where do the fuel lines connect to the fuel pump?

ports


How do you disassemble the hydraulic clutch coupler on the transmission of a 1993 Ford Explorer when the plastic slide is gone?

insert a quick disconnect tool into the coupler , the same tool you would use to disconnect fuel lines.


Does ford have a tool to remove the quick connect clips?

There are a few different styles of "quick connect" clips used on Ford products. Transmissions lines, A/C lines, some fuel lines just to name a few. The best bet is to check at the local auto parts store for specific tools for which type of connection you are dealing with.