Hey Ron==This is a pretty big job and unless you are a pretty good mechanic I suggest you take it to an auto trim shop. The trim has to come off of the door then you have undoo the linkage that holds the window and there are very sharp places inside the doors. If you want to tackle it I suggest you get a manual that shows this repair. You will have it for the next repair. GoodluckJoe
It could be that the window motor has stopped working.
Make sure the window lock button is not engaged on the drivers door. If the button is not engaged then there is a short on the window lock switch. Answer 2:Had to replace the complete drivers door switch assy.I believe rainwater from the driprail falling on the switches is the cause($255.00 from dealer)
The antenna is integrated into the rear window
Rear window relay is inside the pillar on drivers side - its easiest if you remove th rear passenger interior side panels
i am going to be doing this this weekend....this is how my chilton says to do it lower window to down position(if you can) remove door panel remove window weatherstripping remove black window surrond(should be a screw on top of surrond towards back edge) then stationary window should unbolt then remove pins that hold operator to track pick up and pull out the operating window
get a new window switch
Yes. But, I never seen one mounted in the window? If you have a saw to cut the window or a hole in the tray below the window - have at it.
turn bolts to the left, install regulator, turn bolts to the right
You need to drill out the rivets and have a rivet tool to install a new window not to hard to do if you got the proper tools
To install a new window regulator on a MGRZ driver's door, remove the door panel and the wiring attached to the power window mechanism. Remove stereo speaker from the inside door and the window glass. Remove the old window regulator and replace with new.
give more detail to jjmrsf@nctc.com and I will try to help.
i need a diagram to install a window motor on a 1980 gmc truck
I believe the "Related Question" below specifically addresses replacing the door glass on a Taurus / Sable.
It does not matter, the motor will continue to turn either way until stopped by the window regulator.
I need to know the best way to remove and install the new window motor for a 96 Ford Windstar drivers side. Ray
Depends on the raid controller. Windows 7 includes a awefull lot of drivers, so it probably will just work without reinstalling the drivers.
Often the plug in connector at the drivers side switch can becaome loose and break the connection. Remove the switch and check this.