answersLogoWhite

0


Best Answer

The thin trim panel just pops off and the screws are underneath. I just replaced mine. and you will need to remove the whole piece around the stereo, so remember the screws under the dash. Also, if you have buttons on your steering wheel for climate control and radio, they will no longer work when you change the stereo.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the interior dash trim from a 94 88 Royale I am trying to install a new radio but I cannot find an screws or clips that allow me to remove the small trim panel.?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Music & Radio

How do you install jeep power steering pump 2000 Jeep Cherokee Laredo?

Remove air filter assembly. Loosen Belt, place pan under steering box, disconnect high pressure and return hoses. Remove bracket to engine bolts, remove pivot bolt, remove bracket and pump as one whole unit. Then reverse the process to install.


How do you change cabin interior air filter jeep Cherokee 2003?

All the 99/04 WJ Jeep Grand Cherokees come with the cabin filter housing, but the filter was not a standard item. It had to be purchased as an after market accessory. You do not need to remove wiper arms to install the filter. Pull the rubber cowl weatherstripping outward. Remove the weatherstripping on the passenger side about halfway across toward the driver side. Remove the cowl grilled cover, it has plastic fasteners that does not need tools to remove. Start be pulling the end of the panel gently upward enough to pop the plastic fasteners up so you can remove them by hand. Be careful when pulling on the plastic fasteners as they could be very sharp on the edges. There will be an old plastic air inlet cover under that cowl grilled cover. You can either remove the plastic fasteners like above or you can cut the plastic rosebud fasteners. Clean the area and you are ready to install the new filter.


How do you remove the factory radio to unplug the antenna and install satellite radio wire?

you can't do it yourself you have to get help from a pro


How do you install jeep driver side window?

99 Jeep Cherokee Classic. I found out that you don't need to remove the window surround and it will save you some time if you don't. The window can be unbolted from the retractor assembly, but everything else is sold only as single unit. It's fairly easy, really, and only requires a few tools. You have to remove the entire interior door panel and disconnect the wiring harness. Just be careful not to drop the window in the process.


Does the engine move forward on a 90 Pontiac 6000LE to install blower fan If so how do you do it?

remove upper motor mout bolts and pry forward.

Related questions

How do you remove the wiper assembly on a 1991 delta 88 royale Oldsmobile?

The replacement wiper blades will come with instructions on how to remove and install the wiper blades. Your owners manual should also have instructions if you don't follow the instructions on the replacement wiper blades.


How do you get the heating unit past the interior frame on a 2003 ram 1500?

If you have the dash removed, you should have plenty of room to remove and install the ac/heater box.


How do you install a Mitsubishi eclipse driver mirror?

To install the Mitsubishi Eclipse driver mirror, you will need to remove the interior door panel on the driver's side. Then, remove the cover for the mirror screws. Remove the screws and wiring and remove the old mirror. Replace the wiring and screws as you add the new mirror to the car. Then place the cover and the door panel back on the vehicle.


How does one change car interior light bulbs?

It can be quite simple to change the car interior light bulbs. A person has to Turn off the power of the car, Remove the lens, and the bulb, clean the fixture,and install the new bulb and lens.


How do you replace an interior door handle on a Hyundai?

The interior door handle on a Hyundai latches onto the locking mechanism of the door. First remove the old handle by unscrewing it from the door panel. Pull the handle out and remove the locking wire. Install the new unit with the locking mechanism in place. Tighten the mounting screw.


How can one change the bulb for an interior light in a car?

To replace the bulb for the interior light of a car, one should remove the lens cover, remove the burnt out bulb, inspect the socket for dirt or corrosion, inspect the lens cover for damage, check for loose wires then install the new bulb and replace the cover.


How do you uninstall internet explorer and all the files attached to it?

You cannot UN install/remove Internet Explorer because its a part of the OS.


How do you repair an interior door handle on a 1998 Chevy Silverado?

It is not too hard. You will have to remove the door panel, then you will see how the interior handle is riveted to the metal door frame work. You will need to drill these rivets out and install the new handle with either rivets or screws.


How do you install the front driver's side interior door handle on a 2002 Toyota Camry?

You need to remove the door panel. And disconnect it from the wires. After you have to remove the transparent plastic protection covering the door. Remove the screws holding the handle and disconnect the arms. Installation is reverse to removal.


My 2000 GTP interior fan stopped working where is the blower located and how you replace it?

Underneath the glovebox. Have to remove 3 torx screws on it and then the wiring connector. Kinda tricky to install too!!


How do you install front speakers in a 2003 Honda civic?

1. Remove the plastic cover in the interior door handle. with a flathead. 2. Remove the screw. unhook the the release rod from the door handle. 3. go along the interior and pry it open, then pull out. Now you have access to the front door speakers. That's all I can remember when I did mine.


How do you remove a right interior door panel on a 1999 Ford Mustang?

how do remove a 1999 ford mustang interior door panel