Several hundred dollars but depending on the mileage on your vehicle, it may not be worth the money because it may not solve the oil leak problem. My mechanic convinced me not to make the repair - on a high mileage vehicle the groove where the seal sits is likely also worn, so oil just flows past the new seal.
That's bad advice from your mechanic. As with the groove, since the seal is the only thing that sits in that groove and its only function is to keep oil from leaking past, there is NOTHING to cause the groove to wear out unless you are taking a chisel to it . Replacing the seal is not overly difficult just messy and most shops will try and tell you that you have to drop the tranny to get to it, the oil pan is the only thing that needs to be removed, you might find a shop that knows this but they make more money on the labor if the drop the tranny so look about $500 and up to do it just for a $10 seal and $20 oil pan gasket
If you do it yourself, then it will only be the cost of the seal. If you have it done, then you'll have to call around for an estimate. If you have a manual transmission, then you may consider replacing the clutch and throwout bearing, since you're already there.
It will cost you approximately $300 to replace the rear main seal on a Jeep Cherokee. The amount will vary slightly depending upon who does the work for you.
I had mine done on my 1999 Jeep Grand Cherokee and had to have the bearings replaced too, cost me $285.00
On firewall
you need to replace the vacuum.
The fuse for the fuel pump on a Jeep Grand Cherokee CRD is located in the engine compartment in the main fuse box. It prevents the pump from being overloaded and damaged due to a surge.
Their are 2 main bolts that hold on a thermostat housing for an 1987 jeep cheorkee pioneer!!
There isn't a separate computer for just the odometer. Attached to the firewall behind the coolant bottle is the main computer. There are 3 cables that plug into the front of the computer and the odometer is in there. When you buy a new or refurbished computer for your jeep you need the vin number and the odometer reading so the computer can be programmed for your jeep. Meaning the odometer reading is in the main computer
On firewall
you need to replace the vacuum.
A Jeep 4.0L has a two piece rear main seal. You have to remove the oil pan and rear main bearing cap to replace it.
The brake light fuse on a 2003 Jeep Grand Cherokee can be found by looking at the cover to the main fuse box. It identifies each fuse and its location.
The fuse for the fuel pump on a Jeep Grand Cherokee CRD is located in the engine compartment in the main fuse box. It prevents the pump from being overloaded and damaged due to a surge.
The fuel pump relay on a 1992 Jeep Cherokee Laredo is located under the hood. The fuel pump is located under the vehicle and is attached to the main harness.
do all the gages come up (alternator gage, fuel gage ect..) if not replace the main engine computer mine just died goin down the road and i had 2 replace the computer and havent had a problem sunce
Their are 2 main bolts that hold on a thermostat housing for an 1987 jeep cheorkee pioneer!!
spun main bairing
They are 43 Ft. lbs
$7,300.00
350.00