A circuit in which loads are connected side by side is known as a parallel circuit.
Loads are connected side
In a series circuit, loads are connected one after the other in a single path. The current flowing through each load is the same, and the voltage is divided among the loads. If one load fails or is disconnected, all the other loads in the circuit will also turn off because the circuit is broken.
That is described as a circuit in series, as opposed to a circuit in parallel, in which there is more than one loop.
The load side of a panel refers to the section where the circuit breakers are connected to distribute electrical power to various devices and appliances within a building. It is where the electrical load is connected after passing through the circuit breakers for distribution.
In North America the neutral wire is never fused. This is because of the three wire circuit that uses a common neutral. If there are two loads connected across a common neutral circuit and the neutral opens a 230 volt supply will be impressed across both loads as they are now in series with the supply. If both loads were balanced then the voltage drop across both loads would be equal. Dropping 120 volts across each load. Where the problem arises is if the two loads are not balanced and voltage drop goes higher than the manufactures recommended voltage, then the connected device could burn out.
Loads are connected side
Parallel to each other.
series circuit
In a series circuit, loads are connected one after the other in a single path. The current flowing through each load is the same, and the voltage is divided among the loads. If one load fails or is disconnected, all the other loads in the circuit will also turn off because the circuit is broken.
When you have multiple loads in a series, the resistance of the loads is added together allowing very little current to flow through the circuit to power any of the loads, making for a low amperage circuit. If you have your loads in parellel, the resistance of the loads in the circuit is subtracted which allows more current to flow, making for a high amperage circuit.
a compound circuit involves a source a switch and 3+ loads. two of the loads are wired in parallel with a single load connected to the source and top or bottom of the two parallels.
The charge travels through the wires to the loads from the power source where then it powers all the loads connected on the wire. This is beneficial, but also it has its disadvantages. When one of the loads (light bulb) goes out all of the loads connected to the wire go out, instead of where in a parallel circuit the branch that has that load that went out dies. The better choice would be a parallel circuit.
Your question is very muddled and it is difficult to understand exactly what you are asking. Something is in "series" if it is connected in the circuit as a "daisy chain". Thus both loads AND batteries may be placed in series.
false
That is described as a circuit in series, as opposed to a circuit in parallel, in which there is more than one loop.
In a series circuit, batteries are connected end-to-end, increasing the total voltage but keeping the same current. In a parallel circuit, batteries are connected side-by-side, keeping the same voltage but increasing the total current.
12 Amperes is.