You should be aware that 200mW is very different from 200MW. 200mW is 200*10-3 Watts, while 200MW is 200*106 Watts.
Answer
Yes, but the question was correctly stated, 200MW. The output does not depend on the voltage or the number of generators, only the power, which is stated to be 200MW (megawatts) If this is the power actually sent out from the plant, then the energy output in one day is 200 Megawatt.days, or 4800 Megawatt.hours
1000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000 cheese points
A water turbine
It looks as if you can use Ohm's Law to calculate this: V=IR (voltage = current x resistance).
Tidal
Hydroelectricity is a method of producing electricity from flowing water. A large area of water - typically held behind a dam - is forced (by it's own weight) through a turbine generator, which makes the generator spin. When the generator spins, magnets attached to the turbine portion move past magnets mounted on the generator walls just outside the turbine. This produces electrical current, which is harnessed as electricity.
Charge is potential, current is flowing.
Current is measured in Amps, with Ohms law we know Amps are equal to Watts divided by Volts or A=W/V in this case the formula would be: 200,000,000/25000= 8000 Amps
The formula you are looking for is I = W/E. Amps = Watts/Volts.
The current flowing through a transformer's secondary is the current drawn by the load, so it will be exactly the same as the current flowing through your induction motor -assuming that is the load. Don't really understand the point of your question!
A water turbine
The measurement of how fast the current is flowing is the Ampere.
It looks as if you can use Ohm's Law to calculate this: V=IR (voltage = current x resistance).
Flowing electricity is called electric current.
More than I want to calculate for you right now. Also the number is the same whether the bulb is lit (current flowing) or dark (no current flowing). Also tungsten has 74 electrons, of which only 2 are in the conduction band and free to participate in current flow.
as the given cells have the same current flowing in through them (current flowing through the cells connected in series is equal to the current flowing when connected in parallel ) equate the formula's of cells connected in series and cells connected in parallel.thus by equating we get the value of the internal resistor as 2 ohms.
By increasing the field current (current flowing through the rotor windings), the magnetic field generated by these windings will increase. This increased magnetic field will result in a larger current flow in the stator windings (the output of the generator). This in turn causes a larger pull against the rotation of the rotor, causing it to slow down. The governor will then kick in, allowing more steam/ power to the prime mover to keep speed steady. Assuming all is working correctly, the output power will increase as the magnetic field is increased (to a limit).
EMF (voltage) is the force that keeps current flowing in a circuit.
It measures current by creating a coil around the current carrying wire. Current flowing in the wire induces a current in the amp-meter proportional to the current flowing in the wire.