Energy that is put into a pulley but not used is typically converted into other forms of energy, such as heat or sound. Friction and other inefficiencies can cause some of the input energy to be lost in the system.
During photosynthesis, energy from sunlight is captured by chlorophyll molecules in plant cells. This energy is then used to convert carbon dioxide and water into glucose (a form of chemical energy) and oxygen. The glucose can be used by the plant for energy or stored for later use.
To put a string through a double pulley, first thread the string through one side of the pulley. Then, loop the string around the groove of the pulley and thread it through the other side. Make sure the string is running smoothly through both sides of the pulley before using it.
when we used it te pinwheel as to put it in dress or other then a transformation occurs.....
Typically that energy is lost to friction and vibration (ie. sound). Reducing these factors will tend to make an engine more efficient.
When a gas is put under pressure, its temperature typically increases. This is because compressing the gas increases the kinetic energy of its molecules, leading to an increase in temperature.
Put on a new pulley bearing.
because the gravitational energy of the load is absorbed by the pulley, so all effort is put into lifting the object as opposed to keeping it in the air
With the string from the movable pulley
Take the belt off, take the bolt off of the idler pulley, take the pulley off, put a new one on replace the bolt, and put the belt back on
On the fan pulley...
Remove belt. Remove the bolt and then pull the pulley off. Put new pulley in position. Put the belt back on.
the molecules freeze and it turns to the freezing point
During photosynthesis, energy from sunlight is captured by chlorophyll molecules in plant cells. This energy is then used to convert carbon dioxide and water into glucose (a form of chemical energy) and oxygen. The glucose can be used by the plant for energy or stored for later use.
Upper pulley - remove nut on generator shaft. The nut, bell-shaped washer, extra shims, pulley half, used shims, and inner pulley half come off in that order. More shims between the pulley halves will loosen the belt. Fewer shims will tighten it. Put the leftover shims under the bell shaped washer so they'll be around when you put on a new, tight belt. Lower pulley - Put the car in 4th gear and remove the bolt (it's right handed) If the pulley is really stuck, you might need a gear puller to get it off.
They spread out because they gain more energy
Yes the sun is where algae gets its energy.
The roller bearing dates to at least 40 BC, and it was applied to pulley blocks sometime in the dim past of history. There is probably no way to know when someone first put a roller bearing into a pulley block.