0
Chevy Corvette
Launched in 1953, Chevy Corvette is a sports car manufactured by General Motor’s Chevrolet division. Harley Earl designed its first model, a convertible. It is Commonwealth of Kentucky’s official sports car.
4,587 Questions
How do you install hedders on90 Corvette v8 350?
This is one of the few applications where you are going to need to order your headers for that particular car. It is very tight and generic 350 headers are not going to fit. You will also probably need to have the collectors welded to your exhaust pipes to ensure you don't have exhaust leaks getting inside the car.
How do you change your regular lights to hid lights?
There are two ways to do this:
- Replace the entire light unit with a HID light unit compatible with the car, if one is available.
- Use an aftermarket HID conversion that fits standard bulb sockets, and adds HID bulbs and a ballast unit.
HID bulbs require a ballast unit to generate the high voltages required, so are not a direct replacement. In most HID kits, the power can be taken from the existing lighting power supply, so the lights operate as normal.
HID conversion kits are not road legal in some countries.
How do i replace the reverse switch on 2005 corvette?
on a auto trans it should be built into neutral safety switch or gear indicator switch there called now its mounted on the shifter input shaft on transmission where the shift cable is attached, on a manual trans it looks like a oil pressure switch screwed into trans body you can get a temp pass on alldata.com to find circuit diagram and location and test procedure for ten bucks
Yes....try Hypertech or JET.
Do corvette seats fit in a 1979 Camaro?
The short answer is yes, however you don't say what year Vette seats. I put 86 vette seats in my 71. Regardless, the brackets have to be fabbed, it's not a direct bolt in deal. Power has to be ran if you want to adjust them. As well as the switch being mounted somewhere. I'm not sure how a power seat would fit in a 79 with the cat hump in the floor. You'd have to take some measurements, and may have to raise the seat up for the power unit to clear it.
The 86 seats were a great fit in my 71, same back height, relatively same side profile and seat depth. They were a little bit narrower than the stock seats, which was nice. The power seats do sit around 2 inches higher over the front bolster (with the brackets mounted flat to the floor), but that hasn't been too much of an issue. Huge difference in comfort and support.
What is the Brake fluid capacity for 2002 Z06 Corvette?
You are only going to need to get one container of Dot 4 fluid. Now if you have a big brake kit than you may need a little bit more. For the proper bleeding procedures go on over to Smokinvette.com. Good luck!
How do you pop the hood on a 1992 Corvette?
pull hood open lever from inside of the car then slide your hand under hood to the left until you find the side ways lever and push on it to open hood.
When did the Corvette get invented?
So that silly old men could try to look cool. Same reason the Harley was invented.
Oops, thought you said "why". The Corvette made its debut in 1953.
How much is a 1953 Corvette worth?
Depending on the condition, good is anywhere between 200.000 AND 300.000. XLNT, you can practically name your own price as the 1953 How_much_is_a_1963_chevy_truck_worthcorvette is a very rare car.
Where is the oil pressure switch on a 2000 Corvette?
It is on the back of the motor under the intake.
Who created the first washing machine?
phinease and ferb and perry the platapus and Candice and the fire sight girls!
Type your answer here...
How do you tell if the ecm is bad?
On some modern cars, the ECM controls everything from timing to the fuel pump. Many others are not as reliant on it though. It depends on what type of car you have but if it's 2007 or newer, I doubt it would even turn over. If it's older and there's an issue with the ECM, you might notice it not to running as smoothly.
