Construction Tools

trust, rely

Meaning 1: think, judge, suppose, estimate, imagine, assume, gather, reckon

Meaning 2: accept, credit, depend on, trust, have faith in, rely on

Professional repair people use an eraser type sander to sand down the burnt area. Then they custom mix a two part epoxy putty-like glue to match the color and carefully apply and lightly squeegee off the excess. A properly matched patch should be very difficult to detect. A second application may be necessary for deep divots. A countertop specialty store may sell kits to do these repairs

It is called "set" in the teeth. It takes a the sawdust out of the cutting surface so the saw will not bind as much.

Tongue in groover type pliers made by the Channel Lock Inc tool company of USA.

You first make sure the socket in the head is clear and smooth. Fit your shaft into this socket and bang the other end on a firm surface, -the head will settle into position, but now needs to be pounded on with a soft face or dead blow hammer. When the end of the shaft is level with end of head you have it in position. Now you pound a small metal wedge into the end of the shaft to spread it. These wedges are available in all hardware stores in packs of 3-4 quite cheaply.

A hole saw is a round metal cup with teeth on the rim and usually a threaded centre hole to mount it on an arbor. Most common uses are cutting lock holes in doors and holes for faucets in new countertop.

to cut very easily round objects and material

Most blades anymore are marked which end goes towards the handle. If not, the points on the teeth should point away from the handle so that they cut on the forward stroke.

A carbide tipped masonry bit would work well.

I found mine on managemyhome.com:

http://www.managemyhome.com/mmh/products/ManualSearch.action?product.productName=&product.brandName=CRAFTSMAN&product.modelNumber=315216360&docUrl=http://www.managemyhome.com/mmh/lis_pdf/OWNM/L0020136.pdf&docType=OWNM&brandName=CRAFTSMAN&modelNumber=315216360

Coated carbide is the best. Uncoated is next.

Usually a tack hammer. But a brad driver that resembles an awl may be used.

Yes, but not with the usual drill bit. Drilling a hole in glass is accomplished with an abrasive that actually wears a hole through the glass.

Depends on the diameter of the conduit. Try for 1/4" larger diameter drill bit.

12mm

Sometimes, but often the dado comes with a special bushing.

aw, caw, claw, craugh, craw, draw, flaw, gaugh, gnaw, graw, jaw, law, paw, straw, and thaw.

A coping saw is for cutting through wood.

A ball-peen hammer is applied to shape metal .

A hacksaw is used to cut metals. The blades are easily changeable and come in many tooth sizes. Very hard metals like tool steel need many small teeth, so here you would fit a very hard 32 or 36 tpi blade (teeth per inch). Softer metals can be cut with cheaper blades with teeth of about 12 -16 per inch.

While Delta is a brand of drill presses, they would be used like every other drill press. Drill presses are machines that are usually mounted to a table or workbench, and have a lever to bring down the drill, taking some of the burden off the person using it.

A farrier uses an anvil to shape horse shoes to the correct fit for the horse.

Cutting wire or wire nails, twisting wire, and using them as a temporary clamp are all appropriate uses of lineman's pliers. I've even used them to hold a nail in a particularly precarious position so that I could safely drive in the nail with a hammer.