0
Dodge
Dodge is a brand of automobiles, sport utility vehicles and minivans in the US, manufactured and marketed by Chrysler Group LLC in over 60 countries and territories around the world.
2,165 Questions
How do you remove the cam position sensor on a dodge 1500?
It is on the back side of the motor toward the top it has 2 13mm bolts and a wire plug trace the wires on the back of the motor it is hard to see it is only about 3 inches long
Where is the crankshaft sensor on a Dodge SRT 4?
its just below the starter. it might be a bit difficult to remove since you're going to have to remove the starter itself to get to the bolt. good luck.
Should you use 10w 30 oil in a 1999 Dodge Aveger Es?
Use exactly what the manufacture recommends. Listed in your owner's manual and normally on the oil cap.
How do you change the harmonic balancer on a 1999 Dodge 318?
You can go to a local parts place and rent a chrysler harmonic balancer puller. I just did mine on a 2001 and it costed 75.00 and when I was done they gave me my money back. It is the only way to get it off.
How can you get better gas mileage in your 1999 dodge 1500 4x4?
Make sure the tires are set to the proper psi as listed in your owners manual and on the drivers door post. Take off easily and drive the speed limit. Do not carry anything in the truck you do not need. Drive with A/C on at highway speeds and A/C off windows down in the city. Not much else you can do with a large pick-up 4x4.
Why do the turn signals work intermittantly in my 1990 dodge daytona?
Most likely a weak turn signal flasher Could also be a bad switch
What does 5.2 liter mean on a dodge?
That is the displacement of the engine. also called a 318 cu. in.
Where is the oil pressure sending unit on a Dodge 360?
Directly behind the carburetor, just to the side of the distributor.
Where is the oil sending unit on a 89 dodge ramchager 318 v8 4x4?
It is on the back of the engine, next to the distributor.
What is the correct timing for a 1969 Dodge 318 engine?
As far as timing, the engine calls for 5 BTDC originally,. You might want to run it closer to 12, unless you get any spark knock. 8 degrees is a good setting.
Yes you can, The axle will stay attached to the hub in that situation though. After the brakes are off you will see bolts on the rear of the knuckle holding hub on. Lossen bolts about 1/4 in. Using an old socket start to hammer on the bolts until the hub comes loose. This can be a challenge.
Cylinder numbers on a dodge 5.9 liter engine?
pass side 2-4-6-8 driver side 1-3-5-7 diesel 1-2-3-4-5-6
How do you rebuild a 1979 dodge d-50 engine?
buy a haynes book there about 30 bucks. it has a complete tear down and rebuild of the entire car
Where is fuel pump on 1988 Dodge Aries K?
The fuel pump is inside the gas tank. Had to replace mine and boy what a pain! Good Luck!
Did dodge make a 5.9 liter engine in 1999 that was gas?
Yes it was a V8 same old 360 cu in that was made from 1964 till 2002
How to adjust parking brake on 2001 dodge 3500?
the parking brake on 01 3500's are self adjusting. the only other way to further adjust the parking brake is to adjust the starwheels on the back side of the backing plate. there will be a small rubber plug on the top side of the backing plate pull that plug and crank the starwheeels with a small flat blade screwdriver until there is a slight drag. if this does not help the shoes will need to be replaced. this is done by pulling the wheels, axles then the axle nut keeper pin, then the 2 9/16 axle nut, followed by the wheel bearing, then the drum/rotor will slide off where you can service the parking brake assy.
What year did Dodge change the body style for there pickup trucks?
The last big change was 1994, when the body line went from the AD code to BR. In 2002 it went to the DR code.
They estimate at 420 mph though no one has actually floored it they wouldn't be able to hold on
