Electronics Engineering

A central processing unit (CPU), is under the fan and heat sink. The processor creates a lot of heat as it works, and would soon burn-out if not cooled.

first need to find the voltage value to calculate the Power Dissipation. Because

P= I*V

Here V = IR

in given value

I = 30 m A = 0.03 A

R= 5 K Ohm = 5000

V= 0.03*5000=150

V= 150 V

Power dissipation

p= 150*0.03=4.5 Watt

Printed Circuit Board, the circuits/wiring are printed in copper traces on an insulating board.

A fridge may or may not have a few transistors in it, these are electrical components that would probably be part of the control circuitry. Transistors used to be very common components of most electrical appliances.

The cooling process of the fridge has nothing to do with transistors and is handled by a compressor and a heat exchange pump

TTX will block the response at R1 but have no effect at R2

A plain JK flipflop is unreliable as it is enabled by the level of the clock, not the edge. In a master-slave flipflop, the master section captures the new state based on the inputs while the clock level is high, then the slave section captures the new state from the master while the clock level is low. This has the effect of making the flipflop act as if it was falling edge clocked but retains the simplicity of design of flipflops that are level enabled.

two actos and forty four percent of 30 actos

A disc capacitor does exactly the same thing that any other capacitor does, with one difference: it has the lowest value of parasitic inductance of any type of capacitor. As inductance is exactly the opposite property to capacitance, its presence in a capacitor is very undesirable in many applications and can sometimes result in circuit instability.

if a diode has color band markings they are on the cathode end

This is not really practical and the cost to repair (if it could be done) would be about 2 orders of magnitude larger than a new replacement diode costs.

no

A digital converter converts the analog signals that are received by your TV to digital signals. Most TV providers only offer digital TV these days, so you only need it if you're still using analog.

A shunt is connected in parallel with an ammeter.

Any current applied to parallel devices will divide betwen them, so the ammeter will pass only a part of the total current.

If the applied voltage is greater than maximum forward voltage, the diode will get damaged..

10 volts applied to 5 ohms would cause a current flow of 2 amperes.

Current = voltage divided by resistance.

what type of transducer potentiometer

Darlington amplifier has more gain when compared to cascade amplifier .

2 powe N

Transformer

Motors

CT,PT

Genrators

these all are electrical devices

its fantastic,pretty and everything else!! hoope it helps!

15 KOhms times 10 mA = 150 volts.

150 volts times 10 mA = 1.5 watts.

The transmitting signal bandwidth is much wider than would normally be necessary to transmit the information

Some influence other than the information being transmitted is used to determine the transmitting bandwidth

A load line is used in graphic analysis of circuits, having both linear and non-linear parts, representing the constraint the other parts of the circuit put on the non-linear transistor. It represents the response of the linear circuit connected to the transistor. The DC load line describes the DC operation of a transistor graphically.