Electronics Engineering

because that's how God intended the way of the world to be..

problem with uniform quantisatonis

1.real audio signal is concentrated near zero

2.human ear is more sensitive to quantisaton error at small value

using non-uniform quantisaton

quantisaton intrval smaller near zero

Non uniform quantization reduces the signal-noise ratio at low signal levels.

Work it out for yourself. The equation is: Z = E/I, where Z is the impedance, E is the supply voltage, and I is the load current.

each ics are made of transistors.and the ics are used in processors.

Because the bulk charge and surface charge interacting with electric field (forward bias) creates the depletion region.

Capacitors are one of the standard components in electronic circuits. Moreover, complicated combinations of capacitors often occur in practical circuits. It is, therefore, useful to have a set of rules for finding the equivalent capacitance of some general arrangement of capacitors. It turns out that we can always find the equivalent capacitance by repeated application oftwosimple rules. These rules related to capacitors connected in series and in parallel.

The current flow in an electrical circuit depends on the applied electromotive force (EMF, measured in volts), and the total resistance along the entire circuit. Rising EMF or dropping resistance cause increased current flow

The abbreviation, ADC in customs clearance process can mean several things. It can mean Automated Data Capture, which means that a package was inspected with an automated device. ADC can also mean Additional Collection is warranted when a package has arrived by air.

diode is nonlinear device,so device from diode is also nonlinear

As resistance is defined as

R=pl/A

where p=resistivity of the medium

l=length of the medium

A=area

so all these regulates the amount of resistance

1 & 3

To tell you that we need to know the resistance of the entire circuit.

89M77 40+5MFD-440VAC dual run capacitor

ewan ko...................... ikaw ba alam mo

A 'centre tap' refers to a connection midway along the length of a transformer winding. In North America, the 240-V secondary winding of a distribution transformer is centre tapped, and grounded, thus providing the neutral. Each outer terminal of that winding is then at a potential of 120 V with respect to the centre tap. This enables US and Canadian residences to have both 240 V and 120 V supplies. 240 V is then used for high power appliances, such as ranges (cookers), while 120 V is used to supply lower-power appliances, such as kettles, toaster, etc.

The question is incomplete without the voltage across the resistor.

For example:

if V (Voltage across 500 ohm resistor) = 5 Volts,

then,

Current, I = 5/500 Ampere = 0.01 A.

Q point which is quiscent (silent) point is the operating point of a transistor where the variations of collector current and collector-emitter voltage take place when signal is applied.

No, because for a signal to become periodic it must repeat itself in regular intervals of its time period.A 0 Hz signal has a time period equal to infinity , so technically the signal can never complete a full cycle by reaching infinity let alone repeat itself, since the signal is unable to repeat itself in regular intervals its not periodic.

the bias that we are better, smarter, and kinder than others

making EA pin high(i.e connecting it to +5V) means that microcontroller should look for the code in its internal memory. while making it low(i.e connecting it to GND) means that microcontroller should look for the code in the memory which is externally connected by the user. so when there is no external memory connected, simply tie EA pin to +5V supply.

where there is a will, there is a way

CdS is considered as n-type semiconductor because of the deficiency of sulfur. This creates vacancies with a high electron affinity and causes CdS to acquire electrons easily.

Language is the most powerful transmitter of culture.