Lexus IS

Half of 350 is 175. This is calculated by dividing 350 by 2. Therefore, 350 ÷ 2 = 175.

The O2 sensors on a 2002 Lexus IS 300 are located in two primary locations. The upstream O2 sensor is positioned before the catalytic converter, while the downstream O2 sensor is located after the catalytic converter. To access them, you may need to lift the vehicle and remove any necessary components for better visibility and reach. Always refer to a repair manual for specific instructions related to your vehicle.

To remove the exterior door handle on a Lexus IS250, first, ensure the door is unlocked. Remove the inner door panel by unscrewing any visible screws and carefully prying it away from the door frame to access the handle mechanism. Locate and detach the retaining clips or screws securing the handle, then gently pull the handle out from the door. Reassemble in reverse order, ensuring all components are securely fastened.

To reset the power windows on a 2001 Lexus IS300, start by fully lowering the window using the window switch. Once the window is completely down, press and hold the switch in the down position for a few seconds, then pull the switch up to raise the window fully. Keep the switch held in the up position for a few seconds after the window closes. This process should recalibrate the window's motor and restore normal functionality.

To change the vanity mirror light bulb on a Lexus IS 350, first, gently pry open the vanity mirror cover using a flat tool to avoid damage. Once open, carefully remove the old bulb by twisting it counterclockwise. Insert the new bulb by twisting it clockwise until secure, then close the cover to finish. Make sure the new bulb matches the specifications of the original for proper functionality.

To reset the mileage on a Lexus IS 250, you typically need to reset the trip odometer. Start by turning on the ignition without starting the engine. Then, locate the trip meter button on the instrument panel; press and hold this button until the trip meter resets to zero. This will not change the total mileage but will reset the trip odometer for tracking purposes.

To replace the ignition switch on a 2002 Lexus IS 300, first disconnect the battery to ensure safety. Remove the steering column cover by unscrewing the screws, then locate the ignition switch, which is usually mounted near the ignition lock cylinder. Disconnect the wiring harness from the old switch, remove it, and install the new ignition switch by reversing the steps. Reattach the steering column cover and reconnect the battery to complete the process.

To remove the tail light on a Lexus IS250, first, open the trunk and locate the access panel behind the tail light assembly. Remove any screws or clips securing the panel, then gently pull it away to expose the tail light bolts. Unscrew the bolts holding the tail light in place, and carefully pull the tail light assembly out. Disconnect the wiring harness by pressing the release tab and pulling it out before fully removing the tail light.

To program the door handle to open all four doors on a 2008 Lexus IS250, first, ensure that the vehicle is in the "On" position but the engine is not running. Then, press and hold the unlock button on the key fob while simultaneously pressing the lock button three times. Release both buttons and the doors should now be programmed to unlock all at once when using the door handle or key fob. Always consult your owner’s manual for specific instructions or variations.

A Bayliner equipped with a 350 engine typically reaches speeds of around 30 to 40 miles per hour, depending on factors like the boat's weight, hull design, and water conditions. The 350 engine, commonly a V8 configuration, provides good power and performance for recreational boating. However, actual speeds can vary based on specific models and load. Always refer to the manufacturer's specifications for more accurate performance data.

To unlock a 2007 Lexus IS250 with a dead battery, use the physical key hidden inside the key fob. Press the release button on the fob to access the key, then insert it into the driver’s door lock to unlock the door manually. Once inside, you can access the hood and jump-start the battery or replace it to restore electrical function.

The 2001 Lexus IS300 measures approximately 69.3 inches in width, 71.3 inches in height, and has an overall length of about 178.3 inches. It features a wheelbase of 106.3 inches, providing a stable ride. The car's compact dimensions contribute to its sporty handling and agility.

In the Lexus IS250, the power steering fluid reservoir is typically located near the engine, on the driver's side. It is often a small, translucent container with a cap labeled for power steering fluid. To check the fluid level, you can simply remove the cap and look at the markings on the side of the reservoir. Ensure the vehicle is on a level surface for an accurate reading.

To remove the roof aerial mount on a Lexus IS 200, start by carefully prying off any decorative cover or trim piece around the aerial base using a plastic trim tool to avoid damage. Next, locate the mounting screws or bolts securing the aerial to the roof and remove them using the appropriate tool. Once the screws are removed, gently pull the aerial straight up to detach it from the roof, taking care not to damage any wiring. Finally, disconnect the wiring harness if necessary, and the aerial mount will be fully removed.

The fuel filter for the 2001 Lexus IS300 is located along the fuel line, typically underneath the vehicle, near the fuel tank. To access it, you may need to lift the car and remove any protective covers. It's advisable to consult the vehicle's service manual for specific details on its location and replacement procedure.

To troubleshoot a gurgling sound from the AC in an IS300, first check the refrigerant level, as low refrigerant can cause bubbling noises due to insufficient fluid. Inspect the AC drain line for clogs, which can trap moisture and create gurgling sounds. Additionally, examine the evaporator and condenser for any leaks or blockages that might disrupt airflow. If these steps don't resolve the issue, consider consulting a professional technician for a thorough diagnosis.

The Lexus IS200 is equipped with a 2.0-liter inline-six engine that produces approximately 153 brake horsepower (bhp). This model, part of the first-generation IS series, was known for its balance of performance and comfort. The IS200 was produced from 1998 to 2005 and is often praised for its driving dynamics and build quality.

For a Lexus IS250, you typically need a 64mm oil filter wrench with a 14-flute design. This size is specifically designed to fit the oil filter used in most IS250 models. Always check your owner's manual or the specific filter you are using to confirm compatibility.

The fuse panel for a 2005 Lexus RX 330 is located in two main places. The primary fuse box is under the dashboard on the driver's side, to the left of the steering wheel, accessible by removing the cover. Additionally, there is a second fuse box located in the engine compartment, near the battery, which can be accessed by lifting the hood and removing the cover.

To fix LED needles in the gauge cluster of a 2006 Lexus IS250, you'll need to disassemble the dashboard. Start by carefully removing the trim panel and the screws securing the gauge cluster. Once exposed, check the connections to the LED needles; reseat any loose connections and replace any faulty LEDs. Reassemble the cluster and trim, ensuring everything is securely fastened before reconnecting the battery.

To manually close the sunroof on a 2001 Lexus IS300, locate the sunroof's manual override tool, typically found in the glove compartment or trunk. Use a flathead screwdriver to gently pry open the cover near the sunroof motor, revealing a slot for the manual tool. Insert the tool and turn it in the direction indicated (usually clockwise) to close the sunroof. Be sure to do this slowly to avoid damaging the mechanism.

The Lexus IS "No Good Deed" commercial features actors such as Jon Hamm and a dog named Max. Jon Hamm plays the role of a good Samaritan who helps others, showcasing the car's features while navigating various scenarios. The commercial emphasizes themes of kindness and unexpected rewards, all while highlighting the Lexus IS.

The oil drain plug torque specification for a 2002 Lexus IS300 is typically around 29 ft-lbs (39 Nm). It's important to ensure that the drain plug is properly torqued to prevent leaks or damage to the oil pan. Always use a torque wrench for accuracy and consult the owner's manual for any specific recommendations.

On the Lexus IS250, the bank 2 sensor 2 oxygen sensor is located on the exhaust system, specifically after the catalytic converter on the passenger side of the vehicle. To access it, you may need to raise the car and remove any underbody panels if present. It’s often easier to reach from underneath the vehicle. Always ensure the vehicle is safely supported before attempting any repairs.

To remove the car stereo in a Lexus RX400h, first ensure the vehicle is turned off and disconnect the negative battery terminal for safety. Use a trim removal tool to gently pry off the trim panel surrounding the stereo. Once the trim is removed, unscrew the mounting screws securing the stereo, then carefully pull it out of the dash. Disconnect the wiring harness and antenna cable from the back of the stereo to fully remove it.