0
Marlin Firearms
Marlin firearms are manufactured by the 130-year old Marlin Firearms Company in North Haven, Connecticut, USA. Throughout the years, different kinds of firearms have been produced such as rifles, derringers, shotguns and revolvers.
3,064 Questions
How can you tell what year your gun was made?
Serial number or features or original receipt as a rule
Can you purchase a composite stock for a marlin 915Y?
According to Marlin, No they do not. I can not locate one myself
What is the value 0f 1914 model eibar automatic pistol?
it was made in Spain and the metal is questionable for safety reasons. little value.
Marlin 1893 with serial number D1624 manufacturing date?
what is the manufacturing date of a marlin rifle model 1893 with the serial number D1624?
Where can you find a magazine for a Marlin model 57?
Try e-gunparts.com, gun shops, gun shows, internet
What is the value of 33 cal marlin rifle model 95?
Friend has a 33 Marlin for sale. Just what is this rifle and the cost?
Looking for a marlin model 3365c?
Internet firearms auction sites will be your best bet followed by your local gun store and gun show.
What is the value of a marlin micro-vue 4X scope?
I've seen them sell at $39.00 and up to $60.00, depending on condition.
How do you clean the action of a marlin glenfield 75c?
There is two screws holding the barrel & firing mechanism to the stock. On the underside of the stock, remove the screw that is in the stock forward of the trigger & then remove the screw at the back of the trigger, leave the front trigger screw in for now, the stock & the barrel/firing mechanism will separate from the stock. Next with the breach closed, remove the plastic lug at the back end of the barrel/firing mechanism you should be able to pull it out with your fingers. Then with the barrel upsidedown (sights towards the floor) lift the back of the trigger mechanism up & slide back removing it from the breach, exposing the underside of the breach clean everthing you can in the trigger mechanism. Now for the trickey bit. With the barrel still laying flat sights down, you need to slide the bolt halfway back & hold it there as if in the motion of cocking the gun. Using 1 hand to hold it halfway back use your other hand to gently lift the bolt away from the breach enough so that you can slide it forward gently leaving the spring & guide shaft in the rear part of the breach. The piece you would usually grab & pull to cock the gun will fall away be carful not to loose it. Clean everthing you can & repeat step by step in reverse to reasemble your gun. Pretty simple hope this helps Happy shooting
