0
Subaru
Subaru is a Japanese automobile manufacturer known for using boxer engines in their cars above 150cc. A division of transportation conglomerate Fuji Heavy Industries, Subaru also uses all wheel drive drivetrain layout, and produces turbocharged versions of their passenger vehicles.
932 Questions
How do i fix a 1996 subaru hatchback that wont unlock?
Pull the inner panel and unlock it manually. While you're in there pull the old lock cylinder and replace it.
What is the firing order on 1993 Subaru loyale distributor cap?
1-3-2-4
distributor rotor turns counter-clockwise
cylinder layout:
FRONT OF CAR
2 1
4 3
On the distributor cap, #1 position points toward the PASSENGER REAR of the car, and is probably also marked on the cap. #1 cylinder uses the SHORTEST spark plug wire. Then #3 distributor cap position points toward the PASSENGER FRONT of the car, and uses a longer spark plug wire. Then, going counter-clockwise, is #2 distributor cap position, then #4 dist. cap position.
subey - Amendment - I agree, well it really depends, do you want a sissy girls car or do you want a rally made AWD TURBO BOXER POWERHOUSE.
Function of a Subaru oxygen sensor?
The oxygen sensor measures the amount of oxygen in the exhaust gases. Theoretically, if the fuel mix is perfect, then there should be no oxygen in the burned gas ... if it detects O2 it assumes that there wasn't enough fuel ... and adds more.
Why does my 91 Subaru Justy with a carburetor keep backfiring if the timing is known to be correct?
no i have a 91 justy and had the same problem the only difference is that mine is fuel injected it all depends on if the ignition wires on the distributer are correct so first try rearranging them if that doesn't work than loosen the two set screws on the top and the bottom of the distributer keep the car running then slowly twist the distributor back and forth until you hear the engine running smoothly then tighten the set screws and your good to go. Skyler Ellis's automotive answers
Engine oil capacity of 2004 Subaru 2.5 liter?
As mentioned in the owner's manual, it is 4.0 liters, even with filter replaced.
Even Subaru service in Calgary (Centaur) claims that it is 4.4 liters DO NOT believe them as more oil is more harmful than less....
How do you replace the front differential on a Subaru?
You have to remove the entire transmission, and the tranny is in 3 parts. Back of it is the transfer case which houses the center differential (viscus unit), the middle section is the gearbox itself, and the front section (bell housing) is the front differential. All of these sections can be separated and replaced individually.
As for specifics on step-by-step instructions, that's beyond the scope of my patience and technical aspirations of WikiAnswers unfortunately.
Subaru remote programming a269zua111?
1999 Legacy only: Passive arming of the optional 1999 alarm system.
The dealer could program the alarm to arm automatically whether the doors are locked or not. In this mode the doors must be manually locked or using the power lock button or the remote.
In Passive Mode the system will automatically activate in one minute but will not lock the doors. it will arm the alarm even if the doors are not locked. Lock the doors using the power lock switch with the door open. If you are using the remote to lock the doors, there would be no reason to set Passive Mode because locking with the remote would arm the alarm anyway so I'm not sure why this function exists.... To open the doors use the remote or the key, but then the alarm will go off and you'll need
To set Passive Mode:
Open driver's door and remove the plastic step sill that curves up toward the front.
Connect the single-pole white connectors.
the plain gray buttons were used 99-01, colored buttons for 2002-04
replacement note: this style remote has been discontinued and replaced by the new 'TEARDROP' style in late 2009. See your local dealer.
How To Use The Alpine Alarm
Battery #CR2032.
Range? App 50ft. Battery fade, other cars, buildings, walls etc affect range.
1. Locking. Push the large button. This locks all the doors and will set the alarm (if equipped and in setable mode).
2. Unlocking. Push the small button once to unlock the driver's door and disarm alarm, if set. Push the small button a second time to unlock all the doors.
3. Honking horn?
On 1999-2002 models the horn honks once for lock and twice for unlock, 3 times if a door is not closed. This audible honk feature is optional. To turn it off or to turn it on unlock all the doors and hold *both* buttons down until the horn honks once. The horn will always honk 3 times if a door is not fully closed when you lock it.
This was changed in 2003, models to a 'chirp'. There is no longer an audible honk feature. If a door is ajar the system will chirp 5x and the lights flash.
4. Alarm. (optional)
System chirps when locked with the remote if you have an alarm, and no you can't turn the chirp off.
5. Valet mode or alarm off: alarm light (red dot center dashboard display) rapidly flashing 3 times means the alarm is in "Valet" mode and is not setable. The light will stop flashing when you start the car.
To set valet mode or just to disable the security alarm system: 1. unlock all doors 2. physically open the driver's door 3. hold the UNLOCK button on remote for 2+ seconds or so. The red 'security' light will then flash 2 times a second until the car is turned on.
6. Arming the alarm: to make an alarm in valet model arm-able, unlock all the doors and hold the small button down on the remote until the light stops flashing. Now when you lock the doors the alarm will be set and the light will flash on and off, on and off.
7. Alarm goes off?
Push the small button on the remote
OVERRIDING the alarm when you don't have a Remote to disable it.
If you don't have the remote put the key in the ignition and turn it on and off three times and the car will start on the 4th time
8. Program remotes: works on Alpine system.
Unlock all doors, foot on brake, all doors closed. Cycle key quickly but carefully on-off appr 10 times until the car honks one time.
Do not turn the key far enough to start the car, just to the 'on' position so the dashboard lights up.
When the horn honks, open and close the driver's door, press any remote button and that's it.
Program another remote? Quickly open and close the driver's door again and push a button on the 2nd remote. That's it.
When you're done, remove the key and the horn should honk 3 times. You're all set.
Sometime it takes more than 10 on-offs to set program mode. Open/close the door, lock/unlock etc, wait 10 minutes, then try again.
more detailed instructions
If your car is equipped with security system disarm it (with another remote if you have one or by turning the key ON LOCK 3 times in 5 seconds).
Take the key out of ignition (the key has to be taken out).
The next steps have to completed in 45 seconds.
Open and close driver door (the door open light has to come on/off on the cluster).
Put the key into ignition.
Turn the key ON LOCK 10 times in 15 seconds, leaving the key in LOCK position (do not take the key out).
Horn will sound once to indicate you are in remote programing mode (if the horn does not sound start over).
Open and close the driver door (this has to be done within 45 seconds of step 4).
Press and release any button on the remote.
Horn will sound 2 times to indicate that the remote has been programed.
If you have more remotes, repeat steps 8 to 10 (up to 4 remotes could be programed).
Remove the key from ignition.
Horn will sound 3 times to indicate the completion of the procedure.
How do you replace the fuel gauge in a 2002 subaru wrx?
Remove the instrument panel cover from your 2002 Subaru. Remove the fuel gauge retaining screws. Remove the wiring harness from the back of the fuel gauge. Reverse the process to install your new fuel gauge.
Where is the oil sending unit located on a 2002 Subaru WRX?
The oil sending unit on a 2002 wrx subaru is almost under the alternator. I suggest you remove the alternator and it is easier to remove the oil sending unit.
Where is the ECU located on 0990 Subaru Loyale?
On a Subaru Loyale, the ECU is located under the dash. It is behind the glove box on the passenger side.
Where is the intake air temperature sensor located on a 2005 Subaru wrx?
The intake air temperature sensor on a 2005 Subaru WRX is part of the mass air flow sensor. It is located in the air intake duct.
How do you change the thermostat in a 1992 Subaru loyale?
Drain the water from the cooling system. Remove the water hose from the thermostat housing. Remove the thermostat housing retaining bolts. Remove the thermostat. Reverse the process to install the new thermostat.
How do you replace a rear cv boot on a subaru wrx?
Lift the vehicle using a jack. Inspect the CV boot for problems. Mark the axle. Separate the CV from the shaft. Remove the CV boot clamps. Use a mallet to knock the CV joint off the shaft. Remove the boot from the CV axle shaft.
My subaru wrx 1994 turns over but wont start.help?
check the battery check the spark plugs and give it a little gas when u try to start it and by the way sweet car u have the best year of the wrx
The Subaru engine could have a vacuum leak, bad head gasket, stuck choke, or several other things causing the problem. Any of these could give problems then ease up as the engine warms up.
How do you change the time on 07 Subaru Tribeca clock?
To change the clock in the 2006, 2007 and 2008 Subaru Tribeca, perform the following steps: First press "Menu" button on a car's front panel.
Then using the touch screen, choose "MENU" -> "'''Navigation Set Up"-> "Set '''Clock"'''''' Follow the on screen directives on the "Set Clock" screen to adjust hour and minute settings -Perrault Jean-Paul
Where is timing mark for 91 subaru 1.8?
There should be a tiny notch on the back of the pulley. You may need to feel for it with your fingernail. Once you find it you should mark it with white paint.
Why won't car run unless warmed up first?
There could be several reasons for this. 1. Bad Fuel (If this is the case, gas mileage should drop significantly) 2. Faulty Sensor 3. Frozen Fuel Line 4. Condensation in the tank 5. Just too cold ...or it could be thousands of other things I had this same problem with my Chevrolet Cheyenne Pickup. It just needed different fuel. Try putting some anti-freeze gas treatment in the tank. You can find it at the gas station when you fill up.
How do you change turn signal light in 2003 subaru baja?
To change the turn signal light in the 2003 Subaru Baja you need to have a tool box with the necessary tools. Open the screws to access the turn signal light and replace it.
Why are the parking lights staying on after your 1991 Subaru Loyale is turned off?
The switch on the top of your steerin wheel is turned on instead of off The switch on the top of your steerin wheel is turned on instead of off
