0
What else can I help you with?
How do you tighten a valve cover?
There are valve cover bolts around the perimeter of the valve cover. You want these tight but not as tight as you can get them.
How do you replace the valve cover gasket on a 2000 Lincoln LS V8?
There are 8 bolts that hold it on. First remove the cover to the coil packs, Then the coil packs then the vallve cover,
How do you change a valve cover gasket on a 1999 Lincoln Continental?
To change the valve cover gasket on a 1999 Lincoln Continental, first ensure the engine is cool and disconnect the battery. Remove any necessary components like the air intake and ignition coils to access the valve covers. Unscrew the valve cover bolts and carefully lift off the cover, cleaning the surfaces before placing a new gasket. Reassemble everything in reverse order, ensuring all bolts are tightened to the proper torque specifications.
Where are the head bolts located prelude?
Your head bolts are located under your valve cover. Take your valve cover off and you will see them. Hope this info. helped.
What are the size of bolts for miata valve cover?
4x4
How many bolts on 91 305 caprice are in the vave cover?
There are 4 bolts going through the center of the valve cover.
How do you remove valve cover on 1996 caddilac?
The valve cover on a 1996 Cadillac is held on by several bolts around the edge. After removing any hoses, fuel rail, or anything else in the way, remove the bolts to pull the valve cover off.
How do you change valve cover gaskets in 1993 Buick Regal 3.8 engine?
Remove each valve cover (four bolts.) Remove the gasket and set a new one in place. Set the valve cover in place and tighten the bolts to spec.
What are the torque specs for a 94 sc2 valve cover gasket?
89inch pounds is the torque rating for the valve cover bolts
How do you Change valve cover gasket Chevy s10 blazer?
you just pull the three bolts holding the valve cover down. the bolts run right down the middle of the valve covers. pull the valve cover off, replace the old gasket with the new one and tighten the valve covers back on.
How do you remove a valve cover on a 1996 Hyundai elantra?
CAUTION: Some models are equipped with anti-theft-radio make sure you have the activation code before disconnecting battery * Disconnect negative battery cable * Detach the accelerator cable from the cable guides on the valve cover (It's not necessary to remove the cable guides unless you're replacing the valve cover) * Disconnect the PCV and breather hoses from the valve cover * Remove the spark plug wire cover bolts remove the cover and then remove the spark plug wires * Remove the bolts that attach the upper timing belt cover to the valve cover * Remove the valve cover bolts and then remove the valve cover
What is the valve cover torque spec for a 1998 Hyundai Elantra?
The valve cover bolts need to be torqued to 72 to 84 IN-LBS
