0
Ford 600 370 ci 4 bbl batt startersolinoidevoltage reg replaced only loud click when ignition is turned on?
Wiki User
∙ 14y ago
the loud click happens when you dont have a good connection at the starter you are grounded off somewhere down by the starter
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
When you turned the ignition key a click sound acured and then the ignition lights not on only the key light?
You have a flat battery.
Why does your 1994 Ford Taurus not start or click or anything replaced battery starter ignition switch?
Maybe you have a problem in your main wiring harness. No fun.. Could also be an electrical sensor.
Why does your Es300 Lexus sometime start and sometime hard to start?
I had the same problem before. All I hear is a click when I try to turn the ignition on. I just replaced the starter motor and never had that problem again.
Why is 1998 ram van v8 318 turning over with no key in the ignition?
ignition tumblers are worn out. replace ignition switch. Having disconnected the positive battery cable to shut the starter off,I replaced the starter relay fuse. Reconnected the battery, but it would not turn over now although I could hear the starter click. I decided to replace the starter. As soon as I dropped it down off the block and turned it to remove the electrical lines there was a old rusty bolt lodged between the two terminals. A new starter and that,s that.
Why does your Honda CRV go click click click after you turn the ignition off?
From the information given, it is impossible to make a guess. Is it an 'electrical' click or a 'mechanical' click? Where is the "click"noise coming from? The engine compartment? the dashboard area? The ignition switch? the tapep player/radio? More info is needed.
1993 Ford Ranger 3.0L when you turn ignition there is a click and about a second delay then the engine starts it only does this when cold not warm already replaced starter solenoid so what now?
resistance somewhere in starter circuit
Where is the fuel pump relay located on a 1996 240sx?
its by the fuse panel....in the drivers kick panel..for sure but im not exactly sure which of the three that are down there it is. It should "click" when the ignition is turned on unless of course it is not working.
Err code on Nissan Pulsar CD radio?
Switch the ignition to "accessories" or "acc" (turn the key 1 click in the ignition) with "err" displaying on the radio, leave the key in the ingnition for 1-3 hours. "err" should now be replaced with "code" allowing you to enter the correct code a and unlock the radio
Why Loud click from Ford Fiesta on turninng ignition key to position 1?
Probably teeth in ignition column binding
How do you know when your ignition switch has went out?
You know your ignition switch has gone out when you turn the key and there is no click or any noise at all. If there is a click or other audible noise it is probably the spark plug or something of that sort.
How many ignition coils do a 1989 Buick lesabre have?
It has 3. Click the link.
Why would a 1995 Mazda Millenia not turn over or click when the key is turned?
Answer: Most likely battery (you probably surmised this already), however, it could also be a faulty ignition switch or poor connection at the starter or starter module/relay. When the key is turned, do the instrument cluster warning lights come on (& dim slightly)? If so, its not the battery.
