You know your ignition switch has gone out when you turn the key and there is no click or any noise at all. If there is a click or other audible noise it is probably the spark plug or something of that sort.
Ignition or ignition switch could be bad or the selanoid could have went out
my granddaughter has a 1997 GEO prism LSI. i need to know how to remove the ignition switch
If you know where to put the key in, you know where the ignition switch is... Actually, safe to say you should stay away from it.
The ignition switch is one unit and you replace the entire thing. Do not confuse the ignition switch with the key lock tumbler. They are two different things.
You mean, I think, ignition switch module, which is the location of the ignition switch.
Remove the ignition switch retaining ring. Pull the ignition switch out. Remove the wiring harness from the back of the ignition switch. Reverse the process to install the new ignition switch.
I don't know how to change the ignition switch but I have some advice. Don't screw with the ignition switch, buy the whole steering column. It will be cheaper and easier to change.
Begin by removing the retaining ring at the top of your ignition switch. The ignition switch will slide out and you can remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.
Attach the wiring harness to the and of your 1986 Chevrolet Caprice ignition switch. Slide the ignition switch into the ignition slot. Tighten the ignition switch with the retaining ring.
The 1992 Plymouth Cold ignition switch is held in place by a retaining ring. Remove the retaining ring at the top of the ignition switch. Pull the ignition switch out. Remove the wiring harness from the ignition switch. Reverse the process to install the new ignition switch.
I am working on changing my 93 Explorer ignition switch now. As soon as I figure it out I will let you know. :-) Still working on it.
i do not know go to a car stereo install ... store