Vehicles that are around 96's and up have an OBD-II computer link up. This palm held pluggin unit costs around $125 - $150 ish online or at the autopart stores a bit more.
The beauty of it is it will diagnose your check engine light problems and tell you what it is so you know what to have replaced. It also resets the light and clears the codes.
I purchased one and it has been invaluable as it works on any vehicle 96 and up. From Chevy to Ford to Porsche to Rolls Royce.
my 98 Chrysler Sebring cv is not fiereing need information own what maybe causeing this problem
i just put a new computer in my 2002 sebring and now I am having a problem starting the car
I have the same problem I am ready to jack the chrysler up and install a Toyota underneath it
change MAP sensor
Yes.
That will depend on the problem. Could be $100-$1000.
If it is a 2007-2010 there is a spring retainer on the shifter that breaks.
There is a problem with the cam sensor or the wiring to it.
If the Chrysler Sebring won't start after going through a puddle, the problem is probably that the starter relay switch got wet. This is not a common thing but if the starter relay was bad to begin with, moisture will make the problem worse. The starter relay is located on the starter.
A broken timing chain is possible.
If the 2007 Chrysler Sebring 2.71 is not starting without stater fluid in the air filter is could indicate a faulty starter or the air filer may need replacing.
Using a multimeter and spark tester will help find the source of a voltage problem on a 2000 Chrysler Sebring. Having a repair manual on hand will troubleshoot the system, but many electrical problems require tedious sifting through wiring to find the faulty short or ground which is causing an issue.