remove pass side strut, steering knuckle, drive shaft and exhaust to get it out through front wheel well Or take to a qualified mechanic and pay $500 labor Take my advice ONLY REPLACE WITH AN AC-DELCO ALTERNATOR you dont want to pay that kind of labor again
I recently replaced the alternator on my 96' Lumina. 1. Remove the serpentine belt off the engine by locating the belt tensioner and removing the tension req'd to remove the belt. (there is usually a diagram in the engine compt. showing the tensioner location and belt path) 2. Remove required bolts (2) I believe... & elec. harness plug from alternator. 3. Replace alternator & reverse process.
your voltage reg is built into the alternator
on the car its fairly simple disconnect battery. use 3\8 drive ratchet put in the auto tensioner arm for serpentine belt and lift up remove belt. remove bolts going to wish bone mounts at front of engine. tilt engine forward. disconnect wire harness to alternator{should be 10mm} remove bolt from bracket at bottom of alternator. tilt alternator up and remove bolt from bottom back. hope this helped.
there is no alternator on the 1992 Lumina its all electric, so there is no need for one.
How to remove steering wheel on Chevy lumina 2000
Note RADIO CODE before proceeding!!! Disconnect battery Loosen tensioner for the serpentine belt, remove belt. Remove wires affixed to the back of the alternator. Note the wire positions. Remove the 2 bolts holding alternator in place, you may need to remove a brace on the rear of the alternator to the head. Remove alternator. Replacement is the reverse, use the engine decal to reout the serpentine belt properly.
The alternator on a 95 Chevy Lumina 3.4l is replaced by disconnecting the wiring harness, loosening the retaining bolts, and removing the serpentine belt. The alternator can then be unbolted, removed, and a new alternator installed.
Remove the belt from your 1994 Chevy Astro Van 4.3 liter engine alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
Remove the cylinder head from your 1992 Chevy Lumina engine. Remove the head gasket and clean the surface. Put the new head gasket on and reverse the process.
NO.
If it is just like a 1990 Lumina with a 3.1 engine, the alternator sits on top toward the back... There are 3 bolts that hold it on the bracket... DO NOT be fooled... 2 are simple to remove... the 3rd is underneath toward the back... nearly impossible... The simplest way to change it (after taking the belt off of course) is to take the bracket off off the engine... 3 or 4 bolts... Then remove the alternator from the bracket... You will need to remove the hot wire held to the alternator, but be sure to 1st remove the negative wire from the battery or you could shock the @#$% out out of yourself... Hope this helps...
The 1993 Chevy Lumina 3.1 liter engine timing belt can be found on the front of the engine. You will need to remove the front engine cover in order to access the timing belt.