0
How do you remove the driver door panel your door handle is stuck up and won't release?
Wiki User
∙ 18y ago
(1) Wind down the window glass. (2) Bend one piece of stiff steel wire into the form of a small hook like the letter L with the lower portion only about 8 mm long. (3) Unscrew and remove the lock. (4) Use a electric light bulb of at least 60 W and look into the locking mechanism from above the two trims. (5) There is one piece of steel button hanging from the locking mechanism. You insert the steel hook and turn it 90 degree so that it can engage with the steel button of the locking mechanism. (6) Pull the button up and the lock will be released. This is not that difficult. (7) If you cannot locate the steel button, you should try to remove the fabric of the other door and locate the release button so that you know where to look for the release button.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How do you remove the driver side door panel of a 1999 Beetle to replace door lock?
How do you remove the driver side door panel of a 1998 VW Beetle to replace the door handle cable?
How do you remove the driver side door panel of a 90 olds regency?
You will need a torx head screw driver and a Phillips screw driver, remove the screws around the closing handle and the opening handle, then gently pry at the bottom of the panel to pop the fasteners loose working your way up the sides, lift the panel out of the the window slot and over the door opening handle.
How do you remove the driver door panel on your 1996 Ford Explorer?
Remove the screws from the handle and then the door panel will slide up. It has clips that will only let it slide up
How do you remove the driver door interior panel of a Ford Fusion?
remove small round plastic cap behind inside door handle, remove the screw, remove screws from door panel edges, starting at the bottom..pull the panel straight off the door. a door trim tool (if available) may be used to release the clips behind the panel
How do you remove the inside driver's door panel from a 97 Ford Contour?
remove the screws that are around the side and bottom of panel. remove covers located by mirror and by the door hinge. remove the screws you found use a small bent screw driver and put it in the hole on the underside of the the close handle to push the cover off the handle. remove these two screws remove the screw behind the door open handle. pop off the cover that is over the mirror mechinism. now pull up on the panel and voila!
How do you remove an inner door panel on the driver's side on a 1988 Ford Ranger?
Remove all the screws. (There are 2 under the "Close Door Handle" Then, simply lift up the panel. David
How do you tighten the outside driver side door handle on a 1995 Chevy Suburban?
remove the inside door panel and go from there.
How do you remove the driver door panel on a 2002 Chevy Malibu?
Using a screw driver, remove the screws and the clips in the panel of the door and remove the panel gently. Remove any wiring connectors between the panel and the door, then remove the panel the rest of the way.
How do you replace an exterior driver's side door handle on a 1998 Lincoln Mark VIII?
Disconnect positive battery cable, remove all the bolts and screws from the door panel, disconnect the electrical plugs and carefully remove the panel. Remove the two nuts that hold the handle on, remove the linkage and reverse procedure to install.
How do I fix the Driver door latch that won't open from outside?
Remove the inner door panel & start checking for linkage & handle problems
Remove Ford F250 driver inside door panel?
To remove the inside door panel of the Ford F250, first open the door and remove the screws for the door handle. Then, pry the door skin off of the inside starting at the bottom of the door.
How do you remove door panel 2003 Honda civic hx?
After unscrewing all the screws on the perimeter of panel you must slide the interior door handle mechanism to release the panel.
