Before removing it, make sure you find a way to successfully measure the distance of the sensor from the timing wheel. If you don't have a measuring gauge, rule of thumb is between 1-2 credit cards' thickness. You may want to try this as a gauge before removing it.
It is held on by a single, 10mm bolt to the right of the crank pulley. It is black and about the size of a lipstick container. You will need to access it from the bottom of the car with jackstands or ramps, and remove the splash pan.
The wiring harness travels up and you need to disconnect it, it resides just above the Power Steering module.
Once it is installed, attempt to start the car BEFORE putting the splash pan back on. If it does not fire up, it probably needs to be moved a bit closer.
bottom of engine 1 bolt pull it out and put the new one in
a kia 1.8 have crank sensor yes or no
The 1999 Chevrolet Alamo crank shaft position sensor is located on the back of the engine. You will need to remove the rear engine cover in order to access the crank position sensor.
I can not find where is located the position of sensor crank of 1999 nissan sentra 2.0 ( in what point is located in the motor)
The crank sensor is behind the starter. Remover the starter at the back of the engine and you will see the sensor
The 1999 Range Rover 4.6 liter engine crank shaft sensor is located on the back of the engine. The crank shaft sensor is behind the rear engine cover.
Try looking under the starter.
how do you change a crankshaft position sensor on a 1999 chevy camaro z28?
Lock up, No but a bad crank sensor will prevent the engine from starting.
The crank shaft positioning sensor is behind the starter. A real bear to get to.
Under the hood
On a 1999-2005 model Mazda Miata the camshaft position sensor is located on the valve cover towards the rear of the engine (closest to the firewall). It has one 3-pin connector connected to it and one 10mm bolt to remove the sensor