disconnect the battery unbolt the lead wire remove the other terminal wire (small plastic connector) - careful not to break it or the terminal unbolt the three mounting bolts while holding the starter
use anti-seize on the mounting bolts bolt the starter in by holding it and turning the mounting bolts evenly - do each to make sure the starter goes on evenly. Only tighten when the three bolts are near the end. Tighten each one at a time until snug. Bolt the lead wire on Put dielectric grease on the the plastic connector and push it on the terminal reconnect the battery start vehicle
How do you replace a starter in a 1997 F-350 Turbo Pickup?
The starter relay is inside the starter. You will need to replace the starter.
How to replace a clutch interlock switch on a 1997 Ford Ranger XLT
Take it to a repair shop.
Disconnect the - battery cableRaise and support vehicleDisconnect wiring harness at top of starterRemove starter mounting boltsRemove starter
Check and or replace your starter solenoid.
a black cylinder with a big red wire and it on the drivers side
First check the battery. Sounds like it might be dead. If it isn't the battery, it could be the starter relay. They are pretty easy to replace.
how to replace water pump on 2001 ford ranger
how to replace u-joints on 1995 ford ranger 2wd
Remove the starter power wire from the battery that goes to starter. Starter is between the transmission and engine. Remove the 3 bolts from the starter to the transhousing. Replace new starter re-install the power wire.:) Disconnect the battery first!!! Also, besides the battery cable there should also be a starter switch wire (probably a spade connection).
The 1997 Ford Ranger engines are fuel injected , so no carburetor