Contact the dealer.
how to reset hornet alarm,, cause my car can't start..alarm still active,,
to reset the alarm system for a Mercury Sable when the alarm is causing the car not to start, place the key in the ignition. Turn the key only about halfway and leave it in this spot for 10 minutes before trying to start the car.
Turn the ignition switch to the auxiliary position. Do not start the engine. Leave the ignition switch in the auxiliary position for 30 seconds. This will reset your alarm system.
I replace engine but now it wont start.
Put the key back in the door and turn it. This works for my 94 vigor.
in my past experience in alarms there should be a button hidden under the dash in your car The factory alarm is reset by turning the key in either front door or the liftgate.
have you tried disconnecting the battery then reconnecting? HI, according to the owners manual; the alarm system will only allow the vehicle to start if the operator opens the doors with the key. Don't know if this will work though
The factory alarm causing the issue would be the security light flashing above the RPM guage. If the security light is flashing and the car will not start, follow the directions listed below. To reset the factory alarm, turn the ignition switch to the "on" position NOT the start position for 15min. You will see the security light go off after 15min.
unplug the battery, this will reset the car with the alarm disabled
try locking the doors and using the key unlock the passenger side door
after you reconnect the battery you need to reset the alarm system. there should be a reset button (valet button) located under the drivers side of the dashboard. hold the button for 3 seconds then try to start the vehicle.
To turn off the alarm you hold down 'Reset' and press 'Start' Hope this helps!