0
How many bolts are there to be removed on a 1996 Cadillac Eldorado transmission?
Wiki User
∙ 8y ago
Get a manual from DISCOUNTAUTOREPAIRMANUALS.COM and get an answer to both questions. They are about $9
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
Where is blower motor located on 92 Cadillac eldorado?
Under the dashboard on the passenger side. 3 7mm hexhead bolts.
How many motor mounts are there on the 92 eldorado?
one on the bottom one on the top, the rest bolts onto the transmission
How do you remove rear seats on a 1972 Cadillac Eldorado?
Push bottom in then up for bottom. Top has two bolts then lifts up out of clips behind seat
How do you remove the oil pan on a 1997 Cadillac Eldorado one of the bolts is impossible to get to?
i have the same problem on my 97 eldorado. the transmission is too close to the bolt to get a socket around it. you would have to take the whole engine out or take it into a repair shop and be sure to tell them exactly what the problem is so that they dont spend a bunch of time looking for something else wasting your money.
Where is the thermostat located on a 1989 Cadillac Eldorado?
Hope this will help, I replaced mine,88 eldorado, and found it at left end of the top hose, attached by (2)Two bolts. Facing engine,top radiator-hose,follow to the left with point of contact on engine top,secured by with two bolts. Good Luck
How do you change the EGR valve on a 1989 Cadillac Eldorado?
Itt is not a hard job. Simply remove the vacuuum line then the 2 bolts that hold it on. Clean the carbon from the manifold where it bolts. Replace the vvalve and instaall the vac line. GoodluckJoe
Can the flywheel be removed and replaced without removing engine or transmission i'n 1978 Chevy 350 motor?
NO. You will have to remove all the transmission bolts and slide the transmission back enough to get a wrench and your hand between the engine and transmission to remove the fly-wheel bolts.
How do you remove the transmission from 1997 Honda Passport?
I have removed all bolts an linkage, I tried separating the transmission and transfer case and can't get it to come apart
Is it possible to tighten Flywheel on a 2001 Chevy Blazer without removing the housing or starter?
NO. You will have to remove the transmission bolts and move the transmission back alittle after you have removed the driveshaft,transmission lines,crossmember bolts,starter,flywheel dust cover,front driveshaft,torque converter bolts. NO OTHER WAY.
How do you remove 1949 Cadillac door handles?
Wow, a 49 caddy!!!!! The majority of door handles from this era were bolted on from inside the door. The door liner must be removed to access the bolts. I am not 100% sure about your 1949 Cadillac, but suspect it is the same.Wow, a 49 caddy!!!!! The majority of door handles from this era were bolted on from inside the door. The door liner must be removed to access the bolts. I am not 100% sure about your 1949 Cadillac, but suspect it is the same.
How pull heads off 1998 eldorado?
unscrew the bolts
How do you remove the top two bell housing bolts on a 1991 Toyota pickup?
you first remove the engine mounting brackets, then you place a jack under the transmission and remove the cross member bolts that hold the transmission up. after the bolts are removed you can lower the transmission down which will tilt the motor back allowing access to the top 2 bolts from the back side
