ighten the lock nut at the center of the hub.
how to tighten the front chain axle
There is none.... if it not locking in, probably have a bad magnet on hub or switch
You DO NOT adjust those...if you a lot of bounce or bottoming out STOP the jumping of the bike and replace the struts
It should be on the underside frame rail on gear selecter side or frame underside front frame tube near neck. Look under front fender
They are not adjustable, if loose they must be replaced.
it is simple, it is right below the head of of the atv. On a polaris scrambler it is right in front of the left rear fender
As you sit on the ATV the oil filter is on the left side behind the oil storage tank inside the front wheel fender.
Need to know which bearing and which Rodeo. There is a Isuzu Rodeo and a Holden Rodeo. Each has several bearings.
Turn it to left to tighten and right to loosen. In different way turn it to the front bumper and to loosen turn it to the back bumper ....
Not on any post 1998 models. Just a filler plug, located behind the front prop-shaft (drive shaft). The dipstick would be located in the same hole, on earlier models.
Hub and bearing assembly and tighten the bolts to 61-78 ft. lbs. (83-107 Nm)
For the Contour/Mystique/Mondeo front wheel bearing, tighten the axle nut to 290 newton meters, or 213.89 foot pounds.