Ok you will need to take the three bolts off from the top of your wing under the bonnet (not the two large bolts at the top as those bolts are for the bonnet arm). You will then need to take the three bolts from the side of the wing these can be seen when you open the door from behind the wing. The last bolt is at the front under the bumper (you shouldn
The horn is located under the front bumper behind the fog lights. Slide your fingers up under the and remove the 2 clips attaching them then replace it.
With great difficulty, u need to lower the front subframe and dependeing on the engine and gearbox fitted, you may need to raise the engine slightly.
Yes you can my friend had them on his golf mark 4
Front or rear?
no need to replace wheel bearing unless the wheel bearing is worn out
The camshaft sensor is located in the distributor. I believe you have to replace the hole distributor.
The mint mark position is on the front of the coin on the left side, above her shoulder.
You have to buy the wheel bearing assembly.
The mark 2 golf crank sensor is usually on the flywheel.
There is a lever on the left hand side of the column which allows u to adjust the steering
Yes, you are allowed to do this. You are however, not allowed to remove white stakes as these mark the boundary of the course.
mark 3