0
If your drain is sticking up 11.16 off the cement floor and the top part of your drain screws into the bottom half should you pour the concrete to the top of the first piece or leave some room?
Wiki User
∙ 18y ago
For only 11/16" I really don't think it matters. Pouring concrete flush will make it easier if you decide to cap the drain, as the right plug will sit flush with the floor.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How do you install a toilet ring in a concrete floor?
Use a steel ring and Tapcon concrete screws or you can use shields and regular screws.
How do you fix a sticking door handle on an interior door?
If it is the latch that is sticking lubricate it or replace it. If the door sticks on the latch side: Plane down the latch side or if the screws on the hinges are loose tighten them, if necessary use longer screws or fill the screw holes. you can also use longer screws to pull the door jamb closer to the framing making the door opening wider. if the door sticks at the top or the bottom you can cut some material off the top or the bottom
How do you mix premix cement to lay over an existing badly laid cement floor in storeroom?
You will need existing floor to be clean and dry. Layering concrete like this is called a cold joint. Concrete does not like cold joints. That I why big jobs like the cn tower and Hoover dam are all one pour basically. If you have to do cold joints, clean base floor, rent a sacrifice tool at a rent shop, rough up the floor as much as possible, clean all dirt and dust again, cover floor with a bonding agent from a box store, pour new concrete. Over 2" is recommended. Another way to get it to hold is to drill holes into base floor or even put various concrete screws in base floor with just the heads sticking up a little bit so new concrete can grab.
How do you replace the door ajar sensor on a 1997 Dodge Avenger?
on the bottom of the inner door frame there is a little nub sticking out with two screws. you have to unscrew them and pull the nub out and replace it with a new one
Can you install a shower stall over a cement floor?
If you have a drain available. You may need to chip some concrete around the drain to install the bottom half of the drain. With that in place, set the shower over it and the top piece screws into the drain to form a seal. You can build a 2x4 frame and raise the shower up enough to run a drain to a sump or a floor drain.
What if your left click button for the mouse is sticking how can you fix it?
You could pop off the bottom of the mouse if it is the type that has little screws in it and try to clean it out. If not, well they all wear out eventually. Time for a new rodent.
Where can one purchase cheap concrete screws?
If someone wanted to purchase cheap concrete screws, there are a variety of ways which someone can do so. Some of these places are Efix, Fixings and Fastings and Screwfix.
How do you remove plastic cover at bottom of windshield?
there are phillip screws on the cowling, after removing the screws, remove wipers and remove winshield washer hoses on the bottom of the cowling.
What is Lally lock column?
A Lally Lock column is a concrete filled steel column that does not need to have the cap or base plates welded. The top end of the column is fitted with an embedded fastening unit that will accept a 1/2" screw to fasten the cap plate onto the column. The bottom end it just concrete and can be cut with a pipe cutter. Base plates are fastened with concrete screws.
What is a lally lock column?
A Lally Lock column is a concrete filled steel column that does not need to have the cap or base plates welded. The top end of the column is fitted with an embedded fastening unit that will accept a 1/2" screw to fasten the cap plate onto the column. The bottom end it just concrete and can be cut with a pipe cutter. Base plates are fastened with concrete screws.
How do you remove the tail lights on a 2003 Acura RSX?
There are are few bolts on the back of the tail light that can be accessed from inside the trunk. Then there are two screws on the bottom of the lights that can be accessed by laying underneath the rear of the car and sticking your hand up behind the rear bumper.
How do you take off the stand off of your Philips 42pfp5532d-05?
Flip the TV upside down and there are 2 screws you have to take out on the bottom of the stand. Don't remove the 4 screws on the back toward the bottom, They look like the screws but they're not.
