If this question is about the law of property then the answer depends on what the law of your country says about it. It sounds as if it is a fixture, made of plastics, designed to contain some "moveable" objects which are car batteries.
If this automobile battery container, which is made of plastics, is screwed to a wall and/or floor of some business premises, and those premises are an auto repair garage or a battery sales and service shop, then the law in your country may say that it is a fixture which any buyer of that business would expect to own as part of that business. If so, then it should not be removed by the seller of the business.
But this is only a "best guess" as one possible answer and you must check with your local attorney-at-law to get his advice.
<><><>
If you mean can you repair a damaged battery case the answer is generally no. Polypropylene battery cases are not repairable.
Find it. Remove the battery post connections. Find and release the battery hold down clamps or fixture. Reverse the procedure with a new battery. Reprogram the car computer.
what is a sentence for fixture
You need to learn what one looks like and find where yours is. You need a couple of tools to remove and reinstall the battery wire connection and the hold down fixture or bolts. LOL
It would be a fixture.
A lock is a fixture, same as a light, sink, tub. A fitting is usually a part of a fixture, or a fixture is made up of fittings.
The fixture's screws are loose. - singular possessive.The fixtures' screws are all loose. - plural possessive.
Remove the ground cable. Remove the support arms that are in the way.Remove the positive cable. Take a ratchet,a 12" extension, and a 13mm socket and remove the holdown fixture located at the bottom of the battery. Install new battery. Reverse procedure. Done.
If you are talking about the lamp then the answer is no. If you are talking about the fluorescent fixture, it should be. It is the fixture grounding that helps the tube to ignite. because of the close proximity to the metal of the fixture. There are many occasions when the fixture will not operate, but as soon as the ground is connected the fixture operates fine.
The light is wired the same as any voltage fixture. Bring the source voltage to the fixture and connect it to the two fixture wires. If you want to control the off-on of the fixture take the source voltage to a switch first and then out of the switch to the light fixture.
A fixture is what the light bulb goes into.
A pin based fluorescent light fixture is the type of fixture that takes fluorescent tubes. On each end of the fluorescent tubes there are contact pins. These pins are used to hold the tube in the fixture and to supply the voltage to the tube from the fixture's ballast.
It just holds the bulb, does not have a switch in the fixture.