Depending on model year the now discontinued Oldsmobile Silhouette minivan type vehicle may have been equipped with a combination of pressed in and sealed wheel bearings. Sealed wheel bearings involve unbolting the hubs and replacing them with new units. Pressed in bearings must be removed, repacked with fresh grease and then pressed by industrial unit, then reinstalled. Machine shops can also repress in bearings if you do not have a press.
how do you replace a wheel bearing on an 1985 oldsmobile regency 98
how do you replace a wheel bearing on an 1985 oldsmobile regency 98
Hi, I just had a left front wheel bearing replaced on my '02 Silhouette. Symptoms that the part needed to be replaced include: --Whirring noise coming from faulty bearing while driving --Noise increases when turning steering wheel to opposite side of bad bearing (e.g., moving wheel to right with a bad left bearing) --No noise while vehicle is stopped Parts could cost up to $250 depending where it's purchased and who manufactured it. Labor is about 2 hours since wheel and disk brakes have to be removed and re-installed. Hope this helps
you have to replace the wheel bearing hub assembly look up a picture and you will see the bolts are attached to the hub assembly.
First remove wheel and brake caliper and rotor. Unplug wheel speed sensor wire. Remove axle nut. Remove three 1/2 inch head bolts from back side of spindle. Gently tap hub to remove hub/bearing assy. from spindle. Installation is the reverse.
no need to replace wheel bearing unless the wheel bearing is worn out
this is called the lower switch
I had taken my 2000 Silhouette in for other problems and since I had it in the shop, I asked about the lamps on the overhead console and on the steering wheel remotes for the radio. They told me that the lamps are not replaceable, but the whole switch has to bed replaced. I thought that this was quite a bummer.
how do you replace the rear wheel bearing on a Chevy pick up
how to replace front wheel bearing on 1996 Hyundai elentra
How do I put a wheel bearing on with out a wheel bearing press
You can replace the front wheel bearing, on your Kawasaki Mule 3010, by removing the axle. With the axle Remove the wheel bearing will slide off.