0
Where is the crank sensor located on a 2003 Dodge Dakota V six 309 liter engine and how hard is it to replace?
Wiki User
∙ 16y ago
Take the battery cable off for five seconds, and put it back on.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Where coolant temperature sensor is located on engine on 1995 Toyota tercel And how to replace?
The coolant temperature sensor can be found on the front of the engine, near the thermostat. Remove the coolant temperature sensor retaining nut, to replace it.
Where is the Knock sensor in a 2000 GMC Sierra?
they are located under intake manifold The #1 sensor is located in the front of the engine and the #2 sensor is located in the back of the engine. Remember to replace the intake gaskets once you replace the sensor/s. The total time it took me to pull the intake and locate the bad sensor was about 6 hours. Hope this helps
Where is the crankshaft position sensor located on 2001 dodge Dakota 4.7?
On the right side of the engine Block manafold
If the VIC on your 1996 JGC reads that the coolant sensor is bad what do you do?
check/replace the engine coolant level sensor located in the engine coolant overflow reservior (located at the rear of the engine compartment pass. side)
Where is the MAF sensor located on a 1999 Dodge Dakota?
A 1999 Dakota does not have a mass airflow sensor.A 1999 Dakota does not have a mass airflow sensor.
Where is the crankshaft sensor on a 96 dodge dakota 3.9l?
on the passanger side. it i located on the trans housing where the engine and trans meet.
How do you replace a mass air flow sensor on a 2000 grand prix gt 3.8 with sc and where is it located on engine?
your mass air flow sensor is located at the top of your air filter where it connects to the engine. to replace it you remove the two screws unplug the sensor and pull it out and just reconnect the new one in.
How do you replace a speed sensor in a 1999 Chrysler town and country and where is the sensor located?
The input and output speed sensors are located on the front of the trans. They have two wires and the input sensor is closer to the engine.
Where is the camshaft sensor on a 95 Dakota 5.2 v8?
I don't think that there is a camshaft sensor on this engine. There is however, a crankshaft sensor that is located on the passenger side of the bellhousing where it meets the engine. It should be just to the passenger side of the distributor. There is s sensor in the distributor that does the same job as a cam sensor.
How do you replace speed sensor on 1992 Toyota Previa and where is the sensor located?
How do i replace speed sensor on 1992 toyota previa and where is the sensor located
How do you replace the camshaft position sensor on Nissan Altima?
The camshaft position sensor is located near the thermostat housing. You should replace the crankshaft position sensor as well. This one is much harder to locate....it is on the backside of the engine that is between the firewall and the engine block. Both use the same sensor.
Where is the Mass air flow sensor located on 2006 dodge Dakota 6 cylinder?
A 2006 Dakota does not have a mass airflow sensor.A 2006 Dakota does not have a mass airflow sensor.
