Back side of the engine block, on top, behind the intake manifold, just to the driver's side of the distributor.
Its a simiconductor device inside of the alternator.
No it denfinately will not
Check for vacuum leak either under hood or under dash Check for bad vacuum motor underdash Check for bad selector switch
yes
The easiest way would be to purchase the special socket that fits that sending unit to remove and install.
Chevy did not use an Inertia switch.......
It is the switch at the very back of the engine where the engine and transmission meet. and just to the driver's side of the distributor
Near where the oil filter mates with the block and there is a port on the top of the block just behind the intake near the distributor.
At the back of the block, near the distributor.
If you mean the oil pressure switch its located right behind the distributor.Try to reach down towards the transmission and it should be there, most older chevys switches specially on 350 engines are located the same , if not then look around your oil filter area.
oil pressure switch or knock sensor
The 1997 Pontiac Trans Am 5.7 liter engine oil pressure switch can be found on top of the engine. The oil pressure switch will be near the intake manifold.
how to install the oil pressure gauge on a Chevy 350 small block
Chevy did not use an inertia switch. It don't have one.
Yes.
I know on a1987 Suburban the oil pressure switch is located just above the oil filter. Check there. it might there on the '88 also.
drivers side behind the block at the firewall and to the side of the dist. or at the oil filter just in front of it.