0
Replace blower motor resistor usually located in the duct work or out in engine compartment in ductwork by heater motor.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
2000 ford ranger and the blower works but there is no heat or clod air?
It is likely the duct work how ever it can be the fan has come off the fan motor
Need diagram heater switch on 1995 Ford Ranger?
need help with a ford ranger the blower switch all been replace that there all work .but still no heat So told that there are a door that turn from Ac to Heat some where upon the dash .
Blower does not work on a 2000 ford econoline?
fix it
Why does a 1989 ford ranger leak transmission fluid?
There are several seals and gaskets that could leak. You will have to do a little detective work to locate the source of the leak.
Why doesnt the fuel gauge on my 1989 Ford Ranger work?
Your sensing unit may be broken inside of your gas tank. If it is, you would need to purchase another tank.
Will 1994 Ford Ranger 3.0l fuel pump work in a 1992 Ford Ranger 4.0l?
Probably. As a mechanic, I would attempt it.
Will the manual trans from a 4-cylinder Ford Ranger bolt up to the bell housing of a 6-cylinder Ford Ranger?
I am converting a ford ranger automatic (a4ld) transmission 4wd to a 5 speed manual from a 4 cylinder ford ranger. Will it work. What is needed?
Why heat blower does not work 96 ford explorer?
Because its broken
Which years of 5 speed transmission will work in your 93 ford ranger with 3.0 v6 and 2wd?
it will work in the ford
Why does blower fan only work on high on Ford f150?
Blower Motor Resistor is bad. 20.00 part at AZ.
Can a 1988 Ford ranger standard transmition work in a 1992 Ford explorer?
I believe they are swithable if the ranger had the 2.9 V-6. (same mounts)
What year engine will work in your 94 ford ranger 4.0?
Any four liter engine should work in your 1994 Ford Ranger cup truck. The Ford four liter engine may need the motor mounts to be changed.
