Those locks are usually "punched." Try starting it with a screwdriver. Otherwise you may have to call a locksmith. If you have AAA, call them and tell them you lost your key and need another one made, on the spot. It's included in your policy.
Figured it out... Remove plastic trim from on top of radiator support. Remove grill. Remove battery & light sockets. remove 4 bolts... remove headlight assembly. Cheers
Apple Assembly Line ended in 1988.
To remove the tail light assembly on a 1987 to 1989 Chevy Celebrity: On the inside of the trunk next to the quarter panel look for the nuts that hold the rear header to the body. Remove the middle nut, which will be in the center of the tail light assembly. the assembly will then pull outward. When the stud clears then pull to the outside of the car to release the tab from the back up light assembly. If you remove a nut but the tail light assembly did not budge then you probably removed the wrong nut. I like to replace the original nut with a wing nut. That makes future removal easier.
Remove the filler neck assembly then wiggle a siphon hose down into the tank. Be careful not to allow dirt and crud get into the tank.
The 1988 copy of the book In Broad Daylight can be bought at Amazon and eBay. It can also be bought at a bookstore.
Corrosion - Front Line Assembly album - was created in 1988.
On my 1988 Conv the third brake light comes out through the license plate opening.The service manual suggests removing both the gas filler door and rubber boot along with the license.
Charles in Charge - 1984 Where the Auction Is 3-21 was released on: USA: 30 July 1988
how to remove lock cyliner switch 1988 Isuzu pickup
the fuel injectors are located on the top of the throttle body, to get at them take off the air filter assembly, once you remove that you will see the two injectors on the top.
You will need to remove the spindle from the vehicle and use an arbor press to separate spindle from bearing and bearing from hub. There is also a snap ring (circlip) you will need to remove. Use the press to reassemble. If you do not have an arbor press, remove the spindle and bring to a machine shop for pressing.
State of Mind - Front Line Assembly album - was created in 1988.