Take the 2 wires on the relay off and run each into the interior of the car where a suitable switch can be installed. Take the 2 leads and hook them onto the switch. Make sure you have an inline 30 amp fuse installed.
Did you try turning the dimmer switch to a lower setting, sometimes the dome light will stay on even if the door is closed if the switch is set to high. But if the dimmer switch is set propertly, and the light remains on for a few minutes, the problem is most probably a defective relay. There are 3 relays on my 97 Ford Ranger, and I have not found out which controls the light. The relays cost too much just to buy 3 of them. If tou have tried dimmer switch and that did not work try using wd 40 on the the latches. The interior lights stay on until the switch in the door is cleaned and lubed. The switch is within door latches on for ranger. !
The fuel system does not have shut off switch. The system is computer controlled with relays.The fuel system does not have shut off switch. The system is computer controlled with relays.
Reset switch, no. Chrysler does not have those. Fuse for the relays, yes all relays are protected by fuses.
No such switch exists, unless someone installed one. Perhaps an aftermarket alarm was installed and the switch was installed as an upgrade?
on the 88 ranger the switch is above your rearview mirror located on the ceiling on the 88 ranger the switch is above your rearview mirror located on the ceiling
In an electronic switch there are no mechanical/moving parts - the switching action is achieved entirely within the electronic components. Electronic relays are generally a mechanical switch controlled by electronics.
A Chrysler Sebring does not have a reset switch. The fuel system is computer controlled with relays.A Chrysler Sebring does not have a reset switch. The fuel system is computer controlled with relays.
It doesn't have an inertia switch. The fuel system is computer controlled with relays.
Go to your library and get the repair books, they will tell you more than you want to know!
How to replace a clutch interlock switch on a 1997 Ford Ranger XLT
If you are looking for an inertia/reset switch, the answer is no. The engine computer controls the fuel system with relays.If you are looking for an inertia/reset switch, the answer is no. The engine computer controls the fuel system with relays.
No, the system is computer controlled with relays.No, the system is computer controlled with relays.
the answer is the neutral saifty switch relays the starting signal to starter the neutral safety switch relays the starting signal to starter from ignition switch they look the same but plug up different make sure you have right neutral switch
1995 ford ranger back-up lights stay on, replaced switch, how do you check for a bad switch
No, the fuel system is computer controlled with relays.No, the fuel system is computer controlled with relays.
its probably hunted its probably hunted
02 ranger
The 1994 Ford Ranger pickup truck turn signal switch can be found below the dashboard. The switch will be on the drivers side. The turn signal switch should be labeled as such.
It does not have a kill switch or fuel pump inertia switch. The fuel system is computer controlled with relays.
If you are looking for an inertia switch, Chrysler does not use them. The fuel system is computer controlled with relays.
The fuel system is controlled with relays if that is what you are asking.
A Dodge Dakota does not have an inertia or reset switch. The fuel system is computer controlled with relays.
A 2006 Chrysler does not have an inertia switch. The fuel system is computer controlled with relays.
how to replace the netural saftey switch