to take off the engine light take out the positive wire on the battery then hold down the brakes for 30 sec. if the lights still on then sumthing is wrong with the motor
The check engine light comes on in a car when there is a problem with the engine. It will go off or be reset when the problem is fixed.
To reset the check engine light on a 1989 Buick Reatta, first ensure that any underlying issues have been addressed. Then, disconnect the negative battery terminal and leave it off for about 15 minutes. Reconnect the terminal, and the check engine light should reset. If the light returns, it indicates that there may still be an issue that needs to be diagnosed.
You can reset the light by disconnecting the battery for 10 minutes. It will come back on again if you do not correct the problem that set the light in the first place.
Reset inspection light on 1989 bmw 325i
Disconnect the negative battery cable for 5 minutes.
The speed sensor on a 1989 Acura Integra is located on the transmission. It is a small unit with a two-wire clip which connects to the main engine harness of the vehicle.
unhook - side of the battery and let set 5 mins and reconnect and the light will go out.
nothing but take it to Mazda and there computer will reset it, 1hr shop rate..100$ probably a sensor isn't working
take the battery cable off for 15 minutes
Follow the upper rad hose from the rad to engine and it is in a housing on the engine.
The 1989 Acura Integra typically came with a 1.6-liter inline-four engine, known as the B16A, which produced around 108 horsepower. Some models may also feature a different engine configuration, but the B16A is the most common for that year. This engine is part of Acura's first-generation Integra lineup, showcasing a balance of performance and fuel efficiency.
get the CEL checked and fix the problem. Disconnecting the battery for 15 minutes will reset the light on an OBD1 vehicle.