0
1990 econoline van you have no spark at the coil ihave replaced the coil and the ignition module what else could be wrong?
Wiki User
∙ 13y ago
cam position sensor, located inside distribitor. have to take distribitor apart to replace it.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What if your 86 bronco ll will not start evn though you have replaced the battery and ignition coil?
it could be the control module
What could be the problem with an 89 f150 econoline van when it just dies and wont restart?
also check and see if you are getting spark. it may be bad coil,or solonoid. good luck ignition module on the distributer
If your 1986 Bronco XLT engine bogs out and dies after about 20 minutes of driving and you have replaced the ignition module in line fuel pump what else could be wrong?
sounds like an ignition coil
How do you fix a 1996 Ford Thunderbird that shut down at light replaced core fuses fuel pump crank shaft sensors?
Could be the ignition module.
Why does an Oldsmobile skip then run smooth?
Could be ignition module
Where is ecm located on 1983 Chevy c-10 could this be what is wrong no fire tried everything else?
No spark? Have you replaced the ignition module inside the distributor? That would be my guess.
Ea falcon no spark?
could be distributor, coil or ignition module. usually the ignition modules fail first on them.
1990 Jaguar XJ6 has no spark any suggestions and replaced ingnition modue and coil about a year ago. Could the ignition module purchased bought be defective Is there a way to test the ignition module?
I had the same problem with a 93 Jag. I replaced the ignition module, coil, crank sensor, and even the ECU computer and I still did not have any spark. I was stumped and studying the wiring diagram I replaced the ECM Main Relay that was the problem, it fired right up. The ECM Main Relay on the 93 is located in the passenger side of the engine compartment on the firewall and it is the farthest outboard relay. Simple fix. I sure hope this helps someone out there
Gm hei ignition could a 5 pin module be used in place of a 4 pin module?
Yes, absolutely
What are the probable causes for no spark after changing the ignition coil on a 1973 Mercury Cougar?
the ignition control module could be the problem
Will the Ignition module cut off fuel supply?
The ignition module could cut off the fuel supply. The oxygen censor will also cut off the power from an automobile as well.
I have replaced the ignition coil ignition module the distributor cap and the rotor and my 1979 full size Bronco still won't start No fire to the coil can be detected?
You didn't mention whether you've changed the coil wire itself. If it's faulty, you'll get no spark anywhere. Also, the power supply to the coil or module could be at fault.
