If you are talking about the output shaft on the Power Steering shaft. From what I have ran into there is no fix. they do not make rebuild kit for them. But if you have a small leak you can try putting a little brake fluid in the reservoir that may stop the problem, if it is rally bad then try using a commercial stop leak. Lucas oil products makes a really good product. but follow the directions to the letter. good luck,,
Replacing a steering knuckle on a Chevy Colbalt is easy. All you have to is take the steering wheel off and replace the old one.
In replacing the power steering pump on a 1993 Toyota Camry wagon with V6 engine, make sure to replace the steering pressure hose and clamp also. The leaks on both the hose and the clamp are the cause of the broken power steering pump.
how to replace the light bulb on the gear shift on 2004 tracker
You will need a steering wheel puller and a steering lock removal tool You rent them at yourlocal auto parts store
repair timing chain on 2000 chevy tracker
My leaks power steering fluid -- MOST of the time is it the hoses. Try replacing those first. You'll need a good mechanic with the proper tools to replace the pump. But I'd bet one of the hoses is rotted.
How do you change the front rotors on a 2004 Chevy tracker
Probably the hoses for the power steering pump or fittings on the hoses. Try replacing them first. They're not that hard to replace an relatively cheap.
Remove the plug on the bottom of the power steering fluid pump. Drain the power steering fluid out. Replace the plug to the bottom of the power steering pump. Replace the power steering fluid.
Replace just the steering lock unit. The tumblers are old, and they need to be replaces. After replacing the lock, go to a locksmith, and have him re-key the doors to match your new ignition lock.
How to replace power steering pump on Audi
The main thing that will happen after replacing the power steering high pressure house and you don't finish bleeding the air out of the line is poor performance. Air will replace the fluid and prevent the pump from generating the required pressure to operate.