0
1997 mercury villager and keep getting a 4 misfire you've changed the knock sensor plugs wires and distributor cap and rotor still missing could someone help thanks?
Wiki User
∙ 16y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the distributor on a 1998 mercury villager?
The distributor in a Mercury Villager is the round thing at the front of the engine with the six spark plug wires attached to it.
Where is the coil on 1999 Mercury Villager?
The coil UNFORTUNATELY is built in the distributor.
Where is the ignition module located on a 1999 Mercury villager?
Inside the distributor
How do you change the chip in a 1998 mercury villager distributor cap?
There is no "chip" that can be replaced in the distributor, it is serviced as a unit. There is no chip in the distributor cap.
Where is the cam position sensor on a 2001 Mercury Villager?
It is located in the distributor unit.
2001 Mercury Villager V6 3.3 Crank Position Sensor?
the sensor on the 3.3l mucury villager is integrated into the distributor
How do you know if your fuel pressure regulator for your 1997 Mercury Villager is faulty?
it's probably not, check your distributor, i had similar problems, changed regulator, fuel pump, car still would stall or hard start. it turned out to be my distributor. i will repeat, this is a problem with the villager, they go bad quick.
Where is the distributor on a 1996 Mercury Villager?
On the front of the engine, the thing with the spark plug wires attached to it.
Where is the ignition coil on a 2000 mercury villager?
If your car has an external coil, it will be bolted to the engine near the distributor. Otherwise, it is inside the distributor housing.
Where is the cam sencor on 1999 mercury villager?
Cam position is taken from the distributor, there is no external cam sensor.
1999 Mercury Villager code p1320?
Trouble code P1320 means: Distributor Signal Interrupt
Where is the ignition coil located on a 1998 mercury villager van?
The ignition coil is part of the distributor assembly and is inside the distributor. It is not available as a separate part.
