From what i have heard there is a couple clips towards the front of the console. after they are removed you can slide the entire console back to release the hooks securing it to the ceiling.
You will need to remove the headliner. With the headliner removed you will be able to see the overhead console retaining screws. Remove the retaining screws.
Remove the Toyota Camry headliner. The overhead console retaining screws will be visible. Remove the retaining screws and the console will come off.
To remove the overhead console you will first need to disconnect and isolate the negative battery cable. Remove the overhead screws and pull straight down on the console.
Remove the screws that hold the headliner in place. With the headliner removed the overhead console retaining bolts will be visible. Remove the retaining bolts. Remove the wiring harness from the console.
there are 3 screws that hold the console up. one screw in the very front and there are 2 screws inside of the dome light which are accessed by removing the clear cover on the dome light
Pry loose the lens cover and remove the two screws underneath. Then open the sunglass cover and remove two more screws. Disconnect the wiring harness. That's it, at least for the 2001 and similar models.
remove the two light lens be careful not to break them. then remove the two torx screws behind the lens. give a slight pull down on the front of the console to remove the two clips and you are done.
Open the cover and locate the screws on each side of the console. Remove them with a Phillips screwdriver. The console will get a little loose. Do not pry it now or intend to remove it by pulling the loose end. Get the part of the console that is close to the windshield and try to get your fingers in between the ceiling and the base of the console. Pull the console down once you are able to grab the cover. Remove the connector. Installation is the opposite.
Remove the screws
Remove overhead light cover. Remove 2 screws and unit will drop down and hang on front part. Watch screws and don't drop and lose.
Control Panel Front 1. Disconnect the negative battery cable. 2. Remove the overhead console retaining screws. 3. Carefully release the three clips and slide the overhead console forward. 4. Detach the panel electrical connectors. 5. Remove the panel retaining screws. 6. Remove the auxiliary climate control panel assembly from the bezel. 7. The installation is the reverse of removal. Rear 1. Slide the auxiliary climate control panel assembly forward and downward. 2. Detach the electrical connectors. 3. Remove the auxiliary climate control panel assembly from te bezel. 4. Detach the electrical connectors. 5. Remove the screws. 6. Remove the climate control panel assembly. 7. The installation is the reverse of removal.
To remove the radio remove the mounting screws for the center console. Pull the center console off the 2005 Acura TL. Remove the rest of the mounting screws and pull the radio.