Yes. That is by design. Pulling back on the switch is used for 'flash to pass'.
Pull back on the turn signal lever to change from high beams to low beams If the turn signal lever is pushed forward the high beams stay on and if the turn signal lever is pulled back all the way that is the " flash to pass " feature
The neutral start switch mounted on your automatic transmission also serves as the back up lamp switch.
Pull the turn signal lever toward you to switch to high beams and back again Pull the turn signal lever toward you to switch to high beams and back again
300 Feet.
To put the headlights on high beam you push forward on the turn signal lever and then release it , to switch back to low beams pul lthe turn signal lever back The turn signal lever is part of the multi-function switch located inside your steering column cover ( I hope I'm interpreting your question correctly )
You can open the back hatch on a ford explorer by either accessing a switch located in the front console of the car or by finding a switch located between two of the backseat cusions.
Low beams are not working and high beams are. If both low beams out, probably not burnt out bulbs and probably is fuse or a switch problem. Could be the bulbs but doubtful. See the Sources and Related Links section below for light bulb info.
It should either be on the dash board where you can turn your interior lights on or you should pull back on the directional to switch. Cars run with the low beams on and the high beams are switched to in the dark when you feel you need extra light. I feel bad for the people that have been coming in the other direction from this car if its high beams have been on constantly.
the switch is on back top of brake pedal..
Low beams are burned out.
Turn Off Your Automatic Headlight Dimmer Then you can manually Change the High Beams yourself.....
First remove the small Phillips screw on top of the parking light. Pull up the two tabs on back of the main beams. Then the main beams should pull right out for you.