0
you will need to replace the "fan blower resistor" it is about $70 for the part new, $4 bucks for one from a junkyard, it is located under the passanger side of the dash, it has 5 or 6 wires and 2 screws to replace it...it took me 15 mins to do the job...pratice on a car in the junkyard, why screw yours up ;)
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What is the problem when the fan speed only works on high for a 2008 chrysler sebring?
The blower resistor has failed.The blower resistor has failed.
What causes heater blower to operate on high setting only on 2000 Sebring JX 25 L V6?
Defective Blower Motor Resistor Pack.
Pontiac Grand Am 2000 fan only works on high?
Check for a bad blower resistor at blower motor
2000 ford ranger blower only works on high what is the problem?
bad blower,buy a good one and replace
What if your blower works on high in your 2000 dodge caravan?
when a blower motor only works on high, it is usually due to faulty resistor board. Should be located in the duct near the blower. the purpose of this is so the air blown by the blower keeps the resistors cool.
2000 sentra blower only works on high?
You need to replace the blower motor resistor located near the glove box.
Why does your blower motor in Toyota Camry works on only high?
the resistor for the blower motor is busted blower works on high with out it
Why does the blower fan only work on high in a 2006 Chrysler Sebring?
blower motor resistor needs to be replaced
Blower switch only works on low high 2000 Camry?
either the switch or the fan motor
What are the symptoms of a heater blower resistor gone bad in a 2000 dodge ram van?
Blower fan inoperative or only works on high speed.
Why does your fan only work on high in a 2006 Chrysler Sebring?
blower motor resistor
Whats wrong with my 2000 suburban blower motor switch only works on high and getting burning smell when when heater is on?
you have a bare wire touching on your blower motor
