0
2001 Ford Ranger 3.0 engine with the engine light coming on indicating 4 cylinder misfiring you just changed plugs and changed the spark plug wires 1 year ago What would be some of the most likely cau?
Wiki User
∙ 16y ago
most likely cause is #4 coil. later models all have individual coils for each cylander a mechanic can check it pretty quick quick for you
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Can a 93 ranger 6 cylinder and transmission fit in a 92 ranger with a 4 cylinder?
Yes.
How do i repair the slave cylinder on my 1988 Ford Ranger?
The slave cylinder on a 1988 Ranger can not be repaired. The cylinder will have to be replaced, then the system bled.
What mileage does the timing belt on a 1995 Ford Ranger need to be changed?
For the 2.3L 4 cylinder, under normal driving conditions, 60K
What are the cylinder numbers on a Ford Ranger?
where is the number 3 cylinder located on a 2.5 ford ranger engine
When should the timing belt on your 1999 Ford Ranger be changed?
Inspect at 120,000 miles , replace if needed ( Ford maintenance and the Gates website ) for the 2.5 liter , 4 cylinder , in a 1999 Ford Ranger
What year Ford Ranger door will fit your 1992 Ford Ranger 4 cylinder.?
The Ford Ranger body style didn't change from '83 to '92. They changed just about everything else, though. Make sure you know what you're looking for.
Will the manual trans from a 4-cylinder Ford Ranger bolt up to the bell housing of a 6-cylinder Ford Ranger?
I am converting a ford ranger automatic (a4ld) transmission 4wd to a 5 speed manual from a 4 cylinder ford ranger. Will it work. What is needed?
What is the cylinder firing order for a 4 cylinder 1996 Ford Ranger?
Firing order for 1996 Ranger 4-cylinder engine is 1-3-4-2.
1997 ford ranger 4 cylinder has a slight skip on load?
Sounds electical. If it has over 100K miles, have the plugs been changed? After this, it might get expensive.
Can a 6-cylinder ranger transmission fit in to a 4-cylinder ranger?
Several factors are involved with the ability to swap these transmissions. Depending on the Ranger year, the bellhousing and clutch systems can be different sizes, as well as the mounts. With the year of the Ranger and the 6 cylinder transmission then you can determine if the switch is possible.
Where is the slave cylinder on a 1997 Ford Ranger xlt?
The slave cylinder for a hydraulic clutch on a Ford Ranger is inside the manual transmission bellhousing
Does the ignition key for a 1996 ford ranger also unlock the door or is a separate key needed?
It only uses ( 1 ) key , unless a lock cylinder has been changed
