Ford Ranger XLT

Where is the slave cylinder on a 1997 Ford Ranger xlt?

567

Top Answer
User Avatar
Wiki User
Answered
2009-10-13 23:42:29
2009-10-13 23:42:29

The slave cylinder for a hydraulic clutch on a Ford Ranger is inside the manual

transmission bellhousing

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


The clutch slave cylinder for a hydraulic clutch is inside the manual transmission bellhousing


The slave cylinder for your hydraulic clutch is located inside the transmission bell housing


The slave cylinder on a 1988 Ranger can not be repaired. The cylinder will have to be replaced, then the system bled.


the slave cylander is located in the transmission on the 2002 Ford Ranger. Better see a mechanic to do the job.


The slave cylinder for a hydraulic clutch is located inside the manual transmission bellhousing


The slave cylinder for a hydraulic clutch is inside the manual transmission bell housing


The slave cylinder for your hydraulic clutch is inside the transmission bellhousing


The hydraulic clutch slave cylinder is inside the manual transmission bellhousing



No , the 2.3 liter 4 cylinder engine in a 1997 Ford Ranger is not an interference engine


( 8 ) sparkplugs for the 2.3 liter 4 cylinder engine in a 1997 Ford Ranger with Fords twin plug ignition system



If you are talking about the line it compresses in.


On a Ford Ranger , DOT ( 3 ) brake fluid


No , the 2.3 liter 4 cylinder in a 1997 Ford Ranger is NOT an interference engine ( according to the Gates website )


The clutch pedal assembly has a clutch rod that pushes in on a clutch master cylinder. There is a hydro line that goes from the master cylinder to the slave cylinder.



The slave cylinder for the hydraulic clutch on a manual transmission is located inside the manual transmission bell housing


5W-30 , according to the Owner Guide


The slave cylinder is INSIDE the transmission bellhousing , it slides over the transmission input shaft , and then is bolted to the transmission. To change the slave cylinder the transmission has to be removed , but the slave cylinder line can be blead from the bleeder outside of the transmission bellhousing


where is the number 3 cylinder located on a 2.5 ford ranger engine


you just need to hone it out and replace parts with rebuild kit.


I believe that is inside the manual transmission bell housing


can u use e85 in 1997 ford ranger ---------------------------------------------------------------------------------------------- No , all 3 engine sizes ( 2.3 litre four cylinder , 3.0 litre V6 and 4.0 litre V6 ) are designed to use " regular " unleaded gasoline , 87 octane in a 1997 Ford Ranger


well mines not a ranger its a ford f250 super cab 7.5 l now how do i stop the clutch pedle from going to the floor



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.