0
2004 Chevy silverado will not start. Key is in start position but will not crank.?
Wiki User
∙ 16y ago
Dead or weak battery Loose or corroded battery cables Bad Starter Bad starter solenoid Bad Neutral switch
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Yo wont my 89 Chevy silverado will not start its getting fire gas and the starter is good?
Check your crank shaft sensor
Bad crank position sensor?
Crank no start.
Will a Crank position sensor make a engine not crank?
No, it will crank, but it will not start.
2001 jeep grand Cherokee won't start sometimes?
crank or cam shaft position sensor is sometime the issue.it will not fuel if it cannot find the position of the cam or crank
Why are you experiencing cold start on your Chevy pick up?
I need to know why do i need to crank my chevy truck to start ?
What happens when the crank sensor or cam position sensor goes out in a 1998 Chevy Malibu?
crank sensor will cause car to no start cam sensor will only set check engine light kbutlrtech@yahoo.com
Why 2002 Chevy Tahoe will not start it just cranks but will not start what is wrong?
Turn your key to the run position without attempting to crank. Leave it in this position for about 10 seconds. If your Tahoe is equipped with the battery meter, let the meter reach its peak. Then attemp to start.
Will a crank position sensor make an engine crank but not start or just run rough?
Yes it can
Why will your 2003 Chevy Suburban crank but not start?
A 2003 Chevy Suburban will crank but not start if it has no spark or fuel. Checking for a clogged fuel filter or fouled spark plugs can help to resolve the problem.
My 98 silverado z71 starts but have to crank it 2 to 3 times to start where do you start?
it would be the best to buy a new starter
Why wont a Chevy Silverado start?
I was told it could be bad fuel pump.
How to replace Crankshaft Position Sensor on 2001 Chevy silverado any diagrams?
2001 5.3L Silverado, the crankshaft sensor is located behind the start, you have to remove the start to get access too. Raise the vehicle and remove the right front wheel, drop the start and move forward a little bit, this will expose the sensor, have fun...
