2001 5.3L Silverado, the crankshaft sensor is located behind the start, you have to remove the start to get access too. Raise the vehicle and remove the right front wheel, drop the start and move forward a little bit, this will expose the sensor, have fun...
There not 1
Check out the related link for a video on how to replace a crankshaft position on a Ford Focus SE.
how to replace the crankshaft position sensor located in a 2003 kia rio
Replace the crankshaft and camshaft senors and then clear the codes with an oBD II engine scanner and that will fix it.
where is the crankshaft position sensor on 2.5 liter vw jetta
Yes
The crankshaft position is on top of the transmission bell housing on the drivers side. The sensor can be replaced by unbolting and unhooking the plug.
1983 doesnt have a crankshaft position sensor. you have an ignition module located on the side of the distributor.
pull passanger tire
Crank position sensor is located next to the crankshaft. In order to replace it you might have to remove the timing belt. In the most models you just can remove remove the timing belt cover and replace the sensor.
You have to remove and disassemble the engine to replace the crankshaft.If you mean the crankshaft position sensor, then yes. You access it from underneath. It is just above the oil pan on the back of the block.You have to remove and disassemble the engine to replace the crankshaft.If you mean the crankshaft position sensor, then yes. You access it from underneath. It is just above the oil pan on the back of the block.
You can replace the ignition control module and the crankshaft position sensor as required.