NO. You must have an ecm to run the injectors, as they require the proper drop ballast resistors that are in the ecm among other factors of proper fuel injector control that only the ecm can manage properly based on other sensor inputs for different driving conditions.
where is safety switch located and can it be bypassed?
i have a 92 mercury carpi i have fuel i have spark but will not start i do not have power to my injectors not sure where to start on how to get power please help
Gasoline will not dissolve the carbon deposits that clog the injectors but it will cause your engine to not start.
if you have engine oil in your fuel injectors then you have bigger problems then your car not starting..
Starter drag? Injectors leaking - vapor lock? Starter drag? Injectors leaking - vapor lock?
This engine will have seven injectors. 6 are the running injectors and there is a "Cold Start" injector.
To start the Jag, is pretty simple... You have to prime the injectors... on the fuel rail is a treaded nipple, take the cap off and very slowly pour gas into the fuel rail... then the injectors are primed and the car should start... also check your fuel pump it should prime the injectors on its own...
I had a 1987 Chevy Celebrity that would start and then immediately die. It turned out to be bad fuel injectors. I replaced three fuel injectors and the problem has not returned.
check the fuses to the fuel pump and the fuses to the fuel injectors if you have injectors.
see my profile see link.
Probably the fuel pump. Or the injectors.
If it starts in ANY gear, the neutral safety switch has most likely been bypassed.