answersLogoWhite

0


Best Answer

if this is a 4.3 the fuel pump needs to be checked there needs to be at least 55 psi coming from the pump there is a valve on driver side of motor at the back of the throttle body looks like the top of a valve stem , you can get a pressure tester at auto parts store, if the pump is bad, replace pump and sending unit if you don't the pump will go bad again.

User Avatar

Wiki User

โˆ™ 2011-09-12 07:52:40
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: 95 blazer wont start but will turn module good fuel filterpump good runs off starter fluid?
Write your answer...
Submit
Related questions

Blazer only starts with starter fluid?

I have a 1999 Yahama Blaster ATV. The ATV will only start when i spay starter fluid into the air filter, when i spray the starter fluid into the air filter it will only run for a short time. I have cleaned the carbraoter, and air filter seems to be in good working condition as well, the ATV also seems to have good compression.


Why won't your 2000 Chevy blazer start won't even start with starter fluid?

fuel pump,fuel injectors,out of gas,fuel pump shut off valve,fule pump fuse or coil pack or distribitor,timing could be off,crank sensor and or ignition module.


What type of transmission fluid is for 1997 Chevy Blazer?

You can use any type of SAE certified transmission fluid in your 1997 Chevrolet Blazer. You can check the transmission fluid level with the transmission fluid dipstick.


What type of clutch fluid does a 86 Blazer use?

An 86 Blazer does not use a special type of brake fluid. Standard fluid from any auto parts will work fine.


1995 Blazer How many qt to change fluid?

How many qt dose it take to change transmission fluid in 1995 blazer 4.3


What kind of power steering fluid used in a 2001 Chevy S-10 Blazer 4.3 V6?

The Blazer Bravada Power Steering Fluid is the kind of power steering fluid used in a 2001 Chevy S-10 Blazer 4.3 V6. The Van Power Steering Fluid Power Steering Fluid is also a fluid that is used.


What type of brake fluid does a 1977 Blazer take?

Dot-3 fluid


What is the Proper transmission fluid for 1997 blazer?

Dexron III is the correct fluid for this application


What can you substistute trans fluid for in a 97 blazer?

just go buy tranny fluid


What kind of transmission fluid is used for a 98 blazer?

Dexron II. Transmission fluid


Where do you put in trans fluid 1996 Chevy blazer?

You add fluid the same place you check the fluid level.


What is starter fluid?

lubrication lubrication


How do you add transmission fluid to a 1996 Chevy blazer?

you pour it in :)


What is the fluid type for a 1996 Chevy Blazer?

Trasmission fluid is Dexron 3.Trasmission fluid is Dexron 3.


What is the Transmission fluid capacity 97 s10 blazer 4x4 4.3 auto?

for chevy s10 blazer v-6


Where to find transmission fluid dipstick on 96 Chevy blazer?

where can i buy a transmission dip stick for a 1995 chevy blazer


What kind of brake fluid do you put in a 1993 Chevrolet S10 blazer?

DOT 3 Brake Fluid


What kind of transmission fluid and how much for a Chevy 1983 blazer S-10 take?

A 1983 Chevy Blazer transmission will hold 12 quarts of transmission fluid. The manufacturer recommends using a. SEA certified transmission fluid.


How do you check transmission fluid on a Chevy Blazer?

The transmission fluid on a Chevy Blazer can be checked by idling the engine and allowing it to reach operating temperature. The dip stick can then be removed and checked based on the markings provided.


Where do you put starter fluid in?

The air intake .


What kind of fluid do you put in a 2000 Blazer transaxle?

Synchromesh Fluid GM P/N 12345349 or Equivalent


What type of fluid is in the 2001 Blazer transfer case?

DEXRON-III automatic transmission fluid. 2.4 QTS.


What Type transmission fluid for 1995 blazer?

Examine the transmission dip stick, it will tell you what type of fluid it requires.


Wrong transmission fluid in 95 s10 blazer?

Remove the transmission dipstick and read it, it will tell what fluid to use.


Where do you put the brake fluid at on a 1988 Lincoln Town Car?

In the brake fluid reservoir on the driver side near the firewall. The brakes master cylinder (a round shape component) is against the firewall, and then comes out from it there is a boxy module that has brake fluid. It has a screw-on cap to hold the fluid tight in there. Two small metal pipes come out of this boxy module. That module is where you put the brake fluid (DOT 3) in.